Drazice OKHE ONE 120 Instrukcja obsługi i instalacji - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Podgrzewacz wody Drazice OKHE ONE 120. Drazice OKHE ONE 120 17 stron. Flat tank-type water heater for vertical mounting
Drukuj stronę
It is not allowed to handle the thermostat, aside from temperature resetting with a control button.
-
All electric installation handling, adjustment and replacement of the regulation elements shall only
-
be performed by an authorised service company.
The thermal fuse must not be turned off! In case of thermostat defect, the thermal fuse interrupts
-
electric power input to the heating element if the water temperature in the heater exceeds 90 °C.
If you don't use the heater (hot water tank) for longer than 24 hours, or if the facility with heater is
-
unattended, close the cold water inlet to the heater.
The heater (hot water tank) shall be used exclusively in accordance with the conditions specified on
-
the performance plate and in the instructions for electric wiring.
The recommended operating pressure in the hot water circuit is 0.4 MPa. At the hot water
-
discharge we recommend that a reverse flap and an expansion tank are installed (at least 4% of hot
water volume in the manifold) to eliminate reverse pressure shocks.
Both the electric and water installation must follow and meet the requirements and
regulations relevant in the country of use!
4.2 TRANSPORT & STORAGE INSTRUCTIONS
The device shall be transported and stored in dry place and protected from weather effects with
temperature range from -15 to +50°C. During loading and unloading the instructions stated on the
packaging shall be observed.
4.3 DISPOSAL OF PACKAGING MATERIAL AND NON-
FUNCTIONING PRODUCT
A service fee for providing return and recovery of packaging material has been paid
for the packaging in which the water heater was delivered The service fee was paid
pursuant to Act No 477/2001 Coll., as amended, at EKO-KOM a.s. The client
number of the company is F06020274. Take the water heater packaging to a waste
disposal place determined by the municipality. When the operation terminates,
disassemble and transport the discarded and unserviceable heater to a waste
recycling centre (collecting yard), or contact the manufacturer.
5 PRODUCT ACCESSORIES
The product is supplied together with a safety valve. The safety valves are packed and placed in the top
part of the heater package.
It is in your own interest to check the completeness of the accessories.
3-1-2018
- 17 -