Drazice OKHE ONE 50 Instrukcja obsługi i instalacji - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Podgrzewacz wody Drazice OKHE ONE 50. Drazice OKHE ONE 50 17 stron. Flat tank-type water heater for vertical mounting
Drukuj stronę
Thermostat and no other part of the control panel is not a bearing part which can be used for
any handling with the heater.
3.1.1 TEMPERATURE SETTING
Water temperature is set by turning the thermostat knob. The desired symbol is adjusted against the fixed
point on the control panel (Figure 9).
Lower limit of temperature
scope (around 5°C)
Temperature„anti-
freeze" (around 8°C)
Adjusting the thermostat knob to the left backstop does not mean permanent shutoff of the
heating element. When the heater is in use without blocking the daily rate, we do not
recommend the temperature to be set above 55°C. Select the "OPTIMUM" symbol as the
maximum.
4 IMPORTANT NOTICES
4.1 INSTALLATION REGULATIONS
Without a confirmation of performed electrical installation issued by an authorised company, the
-
warranty certificate shall be void.
Check and exchange the Mg anode regularly.
-
You have to apply for approval of a local power supplier to connect the heater.
-
No stop valves can be put between the heater and the safety valve.
-
If the overpressure in the water main exceeds 0.48 MPa, a pressure control valve must be mounted
-
before the safety valve.
All hot water outputs must have a combination faucet.
-
Before filling the heater with water for the first time, it is recommended to fasten the flange
-
connection nuts of the tank.
Figure 9
Fixed mark on the
control panel
Upper temperature
scope limit o (around
80°C)
„Optimum" temper
ature (around 55°C)
- 16 -