Bosch HSLP751UCC Instrukcja serwisowa - Strona 27

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Piekarnik Bosch HSLP751UCC. Bosch HSLP751UCC 45 stron. Built-in wall ovens

Drukuj stronę

58300000181895 ARA EN A

1. Remove the front panel as described in Replacing the Front Panel

Service Assembly section.

2. Using pliers, gently straighten each metal tab so that they align

with the slots in the display board, then lift the board off the tabs.

3. Position the new display board so that the slots in the board align

with the four metal tabs, and firmly push the board downward until

it is securely in place.

4. Slightly re-twist each of the four metal tabs.

5. Reassemble the control panel.

6. Reattach the control panel to the side trim and vent trim.

7. Restore power and test operation.

6.6

Cavity Lights

Each oven cavity utilizes two 120V/25W/G9 base halogen lights.

Replacement bulbs may be purchased locally.

Figure 39 Halogen bulbs (120V / 25W / G9 base

On double ovens, lights are either on or off in both cavities; it is not

possible to operate cavity lights independently.

The cavity light(s) can be turned on in two ways: by pressing Oven

Light or opening the oven door. If Oven Light had not been pressed to

turn light(s) on prior to opening the oven door, the light(s) will turn off

when the door is closed. If Oven Light had been pressed to turn

light(s) on prior to opening the oven door, the light(s) will remain on

after the door is closed.

In other words, the Oven Light switch overrides the door.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JUNE 2014

6.6.1

Each rectangular glass light lens is secured to the lamp receptacle

assembly by two metal clips, which must be opened in order to

remove the glass lens and access the halogen bulb.



CAUTION

 Turn off power to the oven at the fuse or breaker box–light socket

 Be sure oven and lights are cool to the touch.

 Handle glass lenses and glass bulbs carefully.

1. Turn off power to the oven at the main power supply (fuse box or

breaker box).

2. Remove oven racks to provide access to the light lens and

halogen bulb.

3. Optional: on ovens with bottom-hinge doors, the door may be

removed to provide easier access and visibility.

4. Insert the tip of a narrow flat blade screwdriver between one of the

metal clips and the lens at about a 40° angle. Gently pry the clip

upward to open.

Figure 40 Pry the lens clips open using a narrow flat blade screwdriver

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Replacing the Bulb

is live with door open.

Page 27 of 45

800 944-2904