Bosch Series 4 Instrukcja obsługi - Strona 7

Drukuj stronę

1. Installation and Connection

5Installation and connection

T his appliance is designed for domestic use only.

I n s t a l l a t i o n a n d c o n n e c t i o n

This appliance is designed to be fully integrated into

kitchen units.

Please follow the dedicated installation instructions.

The appliance is ready to be plugged in and may only

be connected to a Schuko socket that has been

correctly installed. The circuit breaker must have a

rating of 10 A (L- or B-type circuit breaker).The mains

voltage must correspond to the voltage specified on the

rating plate.

Only a qualified electrician may install the socket or

replace the power cable.If the plug is no longer

accessible once the appliance has been installed, an

all-pole isolating switch with a contact gap of at least 3

mm must be provided for the wiring.

Do not use multi-socket adaptors, power strips or

extension leads. Overloading causes a risk of fire.

Installation and connection

]Causes of damage

C aution!

C a u s e s o f d a m a g e

Heavily soiled seal:

■

appliance door will no longer close properly during

operation. The fronts of adjacent units could be

damaged. Always keep the seal clean.

Operating the microwave without food:

■

the appliance without food in the cooking

compartment may lead to overloading. Never switch

on the appliance unless there is food in the cooking

compartment.The only exception to this rule is when

performing a short cookware test.~ "Cookware

test" on page 10

Microwave popcorn:

■

power too high. Use a power setting no higher than

600 watts. Always place the popcorn bag on a glass

plate. The disc may jump if overloaded.

Liquid that has boiled over must not be allowed to

■

run through the turntable drive into the interior of the

appliance. Monitor the cooking process. Choose a

shorter cooking time initially, and increase the

cooking time as required.

Never use the microwave oven without the turntable.

■

Creation of sparks:

■

must be kept at least 2 cm from the oven walls and

the inside of the door. Sparks could irreparably

damage the glass on the inside of the door.

Do not use foil containers in the

Foil containers:

■

appliance. They damage the appliance by producing

sparks.

Cooling with the appliance door open:

■

the cooking compartment to cool with the door

closed. Do not trap anything in the appliance door.

Even if the door is only slightly ajar, the fronts of

adjacent units may be damaged over time.

Condensation in the cooking compartment:

■

Condensation may appear on the door window,

interior walls and floor. This is normal and does not

adversely affect microwave operation. To prevent

corrosion, wipe off the condensation every time you

cook.

7Environmental protection

E nvironmentally-friendly disposal

E n v i r o n m e n t a l p r o t e c t i o n

Dispose of packaging in an environmentally-friendly

manner.

This appliance is labelled in accordance with

European Directive 2012/19/EU concerning

used electrical and electronic appliances

(waste electrical and electronic equipment -

WEEE). The guideline determines the

framework for the return and recycling of used

appliances as applicable throughout the EU.

If the seal is very dirty, the

Operating

Never set the microwave

Metal e.g. a spoon in a glass

Only leave