DrBrowns natural flow Insta-Feed AC184 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Podgrzewacz do butelek DrBrowns natural flow Insta-Feed AC184. DrBrowns natural flow Insta-Feed AC184 9 stron.
Również dla DrBrowns natural flow Insta-Feed AC184: Instrukcja obsługi (15 strony)
Drukuj stronę
TROUBLESHOOTING TIPS
•
If the warmer is not operating, check that the power cable is connected to the
power outlet and water has been added to warming chamber.
•
If Indicator Light does not come on/warming cycle does not start, warmer may be
cooling down. Wait 10 minutes and try again.
•
If Indicator Light comes on upon plugging in but before Power Button is pressed, it
is possible the Power Button was pressed while the warmer was unplugged. Wait
cool down for 10 minutes before using.
•
If bottle/food is too warm/too cold after warming cycle, note the Warming Guide
only shows approximate amount of water needed. Warming times are impacted
by many variables, so adjust the amount of water added as needed. If the bottle/
food jar is too cold, add slightly more water next time. If the bottle/food jar is too
warm, use slightly less water next time.
ALWAYS TURN OFF, UNPLUG, AND ALLOW THE UNIT TO COOL BEFORE CLEANING.
Bottle Warmer Unit: Wipe outer surface and inside the Warming Chamber with a
damp cloth or sponge using mild liquid soap. Wipe with clean water and allow unit to
air dry. DO NOT SUBMERGE UNIT IN WATER.
Lift-Out Basket, Adapter Ring, Sterilizing Lid, and Measuring Cup: Dishwasher safe
(top rack only) or wash with soapy water. Rinse with clean water and allow to air dry.
It is recommended to de-scale you Insta-Feed™ Bottle Warmer every four weeks to
ensure the unit continues to work properly. To de-scale, follow the steps below.
1. Unplug the appliance from power.
2. Mix 2 oz / 60 ml of white vinegar with 4 oz / 120 ml of distilled water.
DO NOT USE BLEACH.
3. Pour the white vinegar and water mixture directly into the Warming Chamber.
4. Allow the mixture to stand in the unit until any mineral deposits dissolve.
5. Discard the cleaning mixture and rinse with clean water.
6. Wipe the Warming Chamber dry with cloth or allow to air dry.
NOTE: DO NOT USE BLEACH, HARSH ABRASIVES OR SOLVENTS TO CLEAN THE
WARMING CHAMBER OR HEATING ELEMENTS AS THEY MAY CAUSE PERMANENT
DAMAGE AND WILL VOID THE WARRANTY.
7