Anchor AN-1000X Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Anchor AN-1000X. Anchor AN-1000X 4 stron. Anchor mic-25: product brochure
Również dla Anchor AN-1000X: Instrukcja obsługi (4 strony), Specyfikacje (1 strony), Instrukcja obsługi (7 strony), Katalog (2 strony), Instrukcja obsługi (4 strony)

Drukuj stronę

BASIC SYSTEM OPERATION

The AN-1000X is the most versatile powered monitor on the mar-

ket, is designed to amplify the signal from a wide variety of input

sources. Use it on an A/V rack, as a studio monitor, in a trade

show booth or on a US Navy warship, you decide.

Here's How Easy It Is To Use

1. Place the AN-1000X in desired location

2. Plug the power cord into a grounded AC outlet

3. Plug an audio source into one of the three input

jacks on the back panel:

• LINE IN - RCA jack

• LINE IN - 1/4-inch phone jack

• BALANCED INPUT* - XLR jack

4. Turn volume control on front panel to minimum

5. Set power switch on back panel to ON

(red LED on front panel should light)

5. Adjust the volume, bass & treble controls to desired levels

IMPORTANT: To avoid feedback, do not position

a microphone in front of speaker.

*BALANCED INPUT JACK

The balanced XLR input jack allows the AN-1000X to be used in a va-

riety of applications. The input can be user configured for a Lo-Z mi-

crophone or bridging balanced line-level inputs (such as used in the

pro-audio and broadcast industry) . In addition, the input has 15 volt

phantom power which may be switched on or off.

The factory default setting is for microphone-level inputs w/ 15 volts

DC phantom power. Follow the instructions below to change settings.

Change Balanced Input Jack Configuration

1. Set the three dip switches w/ a small pointed object

DIP Switch Option Settings

SPEAKER OUT

The external speaker output jack (1/4"-phone,

unswitched) allows the user to power an auxiliary un-

powered speaker (such as the AN-1001X) . Minimum 8

ohms impedance for auxiliary speakers.

POWER SWITCH

AN-1000X

CONTROL PANEL

AC POWER CORD RECEPTACLE

CAUTION: ALWAYS use shielded audio cables on input connections to prevent interference.

PROBLEMS? Consult the troubleshooting section on the back page of this manual.

NEED MORE HELP? Contact the Anchor Audio Customer Service Department – 888-444-6077.

LINE OUT

The line-level output provides a replica of the com-

posite input signal. Use it for direct recording or to

daisy-chain additional powered sound systems to the

AN-1000X for greater crowd coverage.

BALANCED INPUT

The balanced XLR input jack can be user configured for a Lo-Z micro-

phone or bridging balanced line-level inputs. In addition it has 15

volt phantom power which can be switched on or off.

LINE IN

The line-level inputs (RCA

& 1/4" phone) are used

with input sources such as

VCR's, CD players, musi-

cal instruments, comput-

ers, mixing consoles, etc.

Both inputs can be used

simultaneously w/ the

AN-1000X volume knob

controling composite pro-

gram output.