Alen MPF-12CR Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator przenośny Alen MPF-12CR. Alen MPF-12CR 15 stron. Portable air conditioner
Również dla Alen MPF-12CR: Instrukcja obsługi (17 strony)

Drukuj stronę
Alen MPF-12CR Instrukcja obsługi

Remote Controller Specifications

Model
Rated Voltage
Lowest Voltage of CPU
Emitting Signal
Reaching Distance
Signal Range
Environment
Performance Feature
1. Operating Mode: COOL HEAT DRY FAN and AUTO.
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range : 17 C~30 C.(63 F ~86 F)
4. LCD (Liquid Crystal Display) of all functions.
5. Control function of charactron tube

Introduction of Function Buttons on the Remote Controller

1
TEMP Button
: Push the button to decrease the indoor temperature setting.
MODE Select Button: Each time you push the button, a mode is selected in a sequence
2
that goes from AUTO COOL DRY HEAT and FAN, as the following figure:
AUTO
COOL
NOTE: HEAT only for Heat Pump
RESET Button: When the RESET button is pushed, all of the current
3
settings are cancelled and the control will return to the initial settings.
4
LOCK Button: Push this button to lock in all the current settings.
To release settings, push again.
TIMER ON Button: Press this button to preset the time ON(start to operate).
5
Each press will increase the time ON setting in 30 minutes increments.
When the setting time displays 10:00, each press will increase the time ON
setting in 60 minutes increments. To cancel the time ON program, simply
adjust the time ON to 0:00.
TIMER OFF Button: Press this button to preset the time OFF (turn off the operation).
6
Each press will increase the time OFF setting in 30 minutes increments. When the
setting time displays 10:00, each press will increase the time OFF setting in 60 minutes
increments. To cancel the time OFF program, simply adjust the time OFF to 0:00
7
ON/OFF Button: Push this button to start the unit operation, push the button again to stop the unit operation.
8
FAN SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO LOW
MED to HIGH, then back to Auto.
TEMP Button
: Push the button to increase the indoor temperature setting.
9
R51H, R51H/C
3.0V
2.0V
8m
O
O
-5 C 60 C(-41 F~140 F)
~ ~
DRY
HEAT
FAN
O
O
1
2
8
3
C
SET TEMPERATURE(
/F )
AUTO
FAN
COOL
HIGH
DRY
MED
HEAT
LOW
TEMP
9
7
TIMER
ON/OFF
MODE
ON
5
FAN
TIMER
OFF
SPEED
6
RESET
LOCK
4
Fig. 1
11