Anchor EXPLORER PRO EXP-7500U2 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Anchor EXPLORER PRO EXP-7500U2. Anchor EXPLORER PRO EXP-7500U2 4 stron. Portable sound system
Drukuj stronę
BASIC SYSTEM OPERATION
NOTE: Fully Charge Battery Before First DC Use!
1. Set all Input Level Controls to minimum & Tones Controls to flat
or the middle setting before turning your system on
2. Plug a wired microphone into the MIC 1 or MIC 2 jacks and/or
plug an audio source into the LINE-IN jack
3. Switch POWER to ON, the BATTERY LED will light
4. Slowly increase the Level Control for the input jacks used
to the desired volume
5. Adjust BASS & TREBLE controls to desired sound quality
IMPORTANT: Make all connections w/ shielded
cables to avoid hum, buzzing or interference.
NEED MORE HELP? Visit Our Website:
www.anchoraudio.com
CARING FOR YOUR BUILT-IN BATTERY
An automatic charging system is built-in to your Explorer PRO Sound System.
It is designed to properly charge and maintain the systems built-in battery.
CHARGING THE BATTERY
1. The Battery Level Indicator Light will show a flashing red light
when battery is low
2. To charge the battery, plug the AC power cord into the Explorer PRO
3. Plug the other end of the cord into AC outlet
4. The Charge Indicator Light will show flashing green light when
charging is complete
To preserve the life of your battery it is recommended that it be fully charged as
soon as possible after every use regardless of the length of operation.
NOTE: System Can Be Used While Battery Charges!
OPERATING IN AC MODE
Plug your sound system into an AC outlet. Operate the system normally while
the built-in battery charges automatically. The Charge Indicator Light will
show a solid green light when battery is charging and a flashing green light
when charging is complete.
IMPORTANT: Always Store Your System w/
Battery Fully Charged!
4
WIRELESS RECEIVERS 1 & 2
(see page 6)
RX INDICATOR LIGHTS FOR
WIRELESS RECEIVER 1
A solid red light on one of the RX Indicator
Lights indicates that the sound system is getting
good reception with the wireless microphone
A solid red light on both RX Indicator Lights
indicates that the sound system is getting opti-
mum reception with the wireless microphone
RX INDICATOR LIGHTS FOR
WIRELESS RECEIVER 2
WIRELESS MICROPHONE 1
LEVEL CONTROL
Adjust knob to control
wireless microphone levels
WIRELESS MICROPHONE 2
LEVEL CONTROL
AC POWER CORD INLET
EXPLORER PRO SOUND SYSTEM
CONTROL PANEL
Model Shown: EXP-7500U2
BATTERY LEVEL INDICATOR LIGHT
The Explorer PRO sound system features a built in Battery Level Indicator Light that
shows the battery level in two steps at power on.
1. RED (solid) : Battery is ready for use
2. RED (flashing) : Battery level becoming low
(system auto-shut off in 45-60 minutes)
LINE OUT - OUTPUT JACK
Balanced 1/4" – provides a combined
The 1/8" (3.5 mm) jack input is used to hook up an iPod, a portable CD/
output of all active system inputs
MP3/ tape player, laptop computer, or similar external audio source
Record your presentation or connect to
The 1/4" unbalanced input can be used for other communication devices
another powered sound system
including a mixer or daisy chaining together multiple Explorer speakers
POWER SWITCH
BATTERY LEVEL INDICATOR LIGHT
CHARGE INDICATOR LIGHT
The Explorer PRO sound system is equipped with a built in rapid charger, designed to
quickly charge and maintain the battery. If the Charge Indicator Light is:
GREEN (solid): Battery is in good condition, rapid charging has begun
GREEN (flashing): Battery is fully charged
LINE IN - INPUT JACKS
LINE IN LEVEL CONTROL
TONE CONTROLS - BASS/TREBLE
WIRED MIC LEVEL CONTROLS
MUSIC/ SPEECH BUTTON
In situations where you're speaking to a
larger crowd or in a noisy environment, just
push the Music/Speech button in and give
your voice an added boost
To return back to normal use, just push the
Music/Speech button again
VOICE OVER BUTTON
Push the "Voice Over" button in to have
the music automatically lowered when you
speak through a connected microphone
Music will return to original level when you
mic use/speaking stops
SPEAKER OUT - OUTPUT JACK
Connect the system to a Explorer PRO
unpowered companion speaker
CHARGE INDICATOR LIGHT