Anchor MegaVox Pro Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Anchor MegaVox Pro. Anchor MegaVox Pro 7 stron. Public address system
Również dla Anchor MegaVox Pro: Instrukcja obsługi (4 strony), Instrukcja obsługi (9 strony), Instrukcja obsługi (10 strony)
Drukuj stronę
MegaVox Pro Public Address System Owners Manual
CARING FOR YOUR BUILT-IN BATTERIES
It is very important that you fully charge the batteries in your new
pa system before the first time its used. To preserve battery life
it is also recommended that batteries be fully charged as soon as
possible after every use regardless of the length of operation.
UNDERSTANDING THE BATTERY LEVEL INDICATOR
LED Flashing Red: Battery charge is very low, in 15-30 minutes
the Battery Protection Circuit will turn the system off.
LED Off: Battery is completely drained and must be charged.
NOTE: System can be used while batteries charge!
OPERATING IN AC MODE
Plug your sound system into an AC outlet. Operate as normal
while charging the built-in batteries at the same time. The Charger
LED will light during charging and flash when the battery is fully
charged.
BATTERY SERVICE TIME
With the batteries fully charged you can expect approx.:
8-12 hrs @ Medium Volume 3-6 hrs @ Full Volume
of continuous music input (longer for speech). Service time will
vary depending on control settings and use of accessories
(built-in wireless receivers and/or a companion speaker).
IMPORTANT
: For longer battery life always store your system
with batteries fully charged!
Waste electrical and electronic products must not be disposed
of with household waste. Please recycle where facilities exist.
Check with your Local Authority or Retailer for recycling advice.
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
MADE IN USA
SIX YEAR WARRANTY
CHARGING YOUR BUILT-IN BATTERIES
An automatic charging system is built-in to your MegaVox
PRO PA System. It is designed to properly charge and
maintain the systems built-in batteries. To charge
batteries:
1. Plug the power cord into your
sound system
2. Plug the other end of the cord into
AC outlet - Charger LED will stay on during
charging
3. Batteries fully charge in approximatly
6-8 hrs - Charger LED will flash
When in AC mode the system automatically transfers
power from the battery charger to the power amplifier at
high volume output, causing the Charger LED to flicker.
SYSTEM STORAGE & BATTERIES
Always store your sound system with the batteries fully
charged. For extended periods of storage leave the
system plugged into an AC outlet. If this is not possible,
charge the system at least once each month for a
minimum of 24 hours.
6