Anchor Megavox Pro MEGA-6000U1 Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki Anchor Megavox Pro MEGA-6000U1. Anchor Megavox Pro MEGA-6000U1 16 stron. Anchor mega-6000u1: brochure
Również dla Anchor Megavox Pro MEGA-6000U1: Katalog (2 strony), Instrukcja obsługi (4 strony), Specyfikacje (1 strony), Specyfikacje (1 strony), Instrukcja obsługi (8 strony)
Drukuj stronę
Wireless Microphone Operation
NOTE:
Both the receiver and microphone must be set to the same channel.
When using a
dual wireless
unit, make
sure each
microphone is
set to a
different
channel
frequency.
MEGA-6000U1 Only: The audio signal from the built-in wireless
receiver is fed to the MIC 1/Wireless input. Unplug any other mic
from the MIC 1/Wireless input when using the wireless system.
Replacing Transmitter Battery
CAUTION:
Handheld Transmitter:
Harmful
feedback may
occur when
walking in
front of a
sound system
or speaker
with a
wireless
microphone.
Always point
mic away
Body-pack Transmitter:
from speakers.
NOTE:
Transmitter
power switch
must be in the
OFF position
when
changing
batteries
1. If you are using a body-pack transmitter, insert the plug from
the mic into the jack marked MIC on the transmitter.
2. Turn the transmitter power switch to ON.
(The red LED will flash when the mic is turned on.
If the red LED stays on, the battery is low.)
3. Turn the MegaVox Pro power switch to ON.
4. The RX indicators will light (one indicator at a time lights)
when the wireless signal is being transmitted and received.
1. Unscrew battery compartment cover on lower end of mic.
2. Install 2 fresh 'AA' alkaline batteries.
3. Replace the battery cover.
1. Slide open battery cover on front of transmitter box.
2. Install 2 fresh 'AA' alkaline batteries.
3. Close the battery cover.
WIRELESS OPERATION
Place batteries into slot
and slide forward
11