Anchor 32 Aurora Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Namiot Anchor 32 Aurora. Anchor 32 Aurora 13 stron.
Również dla Anchor 32 Aurora: Instrukcja instalacji (13 strony)
Drukuj stronę
Introduction
The installation of this Aurora Tent should be performed/supervised by knowledgeable tent installers with a clear understand-
ing of safety issues as well as the methods of anchoring. The requirements as specified must be followed. The installer/
owner must read the assembly instructions completely prior to any installation. Particular attention must be given to anchor-
ing! See Caution Statement on back page of this manual
Work from step to step.
Before erecting any tents or membrane structures, first obtain permits and approvals as required from the local building and
fire code officials on the jurisdiction of your installation.
PLEASE PAY SPECIAL ATTENTION TO SAFETY WARNINGS AND CAUTIONS FOR PREVENTION OF ACCIDENTS.
Regarding the contents of this document:
The illustrations and photos are made to show clearly the construction and dismantling procedures and also for identification
of the components. Not all illustrations/photos correspond to the actual dimensions and size. Explanations and/or notes have
been added to these illustrations/photos.
If you have questions, please call your sales representative at the phone number listed on the front of this manual.
Safety Notes
•
Please read through this assembly manual completely before beginning your installation. Be sure the proper equipment
and safety precautions are in place. We hope that you enjoy the design features of the tent each time the unit is installed.
•
Consult your local utility locator service or the National Utility Locating Contractors Association (NULCA) prior to
installation.
•
Prior to actual tent assembly, be sure to look up, down, above & below for obstacles, pipes, wires, trouble, etc.
•
Be alert to avoid contact of Tent poles with any overhead power lines near the site.
•
Keep site clear of debris to avoid tripping, especially while carrying tent poles or bundle of fabric.
•
When moving tent sections by hand, use proper lifting techniques to protect the back.
•
The installation method described here requires coordination of tasks between workers. A safe installation is dependent
on that coordination. Work cooperatively as a team.
•
Replace used or damaged components with original new ones.
•
To prevent injuries, wear suitable protective clothing such as hard hats, steel toed shoes, etc.
•
Do not drag bundle of fabric on concrete, asphalt, or ground as this can cause damage to the fabric from abrasion through
the bag.
•
This tent is manufactured for use as a temporary structure. Evacuation is recommended if threatening or windy weather
occurs. See caution on back page of this manual.
•
Anchor uses a nominal safety factor of at least 2 when figuring staking guidelines.
* IMPORTANT NOTE:
TANT WARNING ABOUT NUMBER OF STAKES SUPPLIED.
THE INSTALLER MUST USE THE LOCAL SOIL CONDITIONS TO CALCULATE THE ACTUAL NUMBER OF STAKES
REQUIRED AND IS RESPONSIBLE FOR THE STAKING PATTERN AND CONFIGURATION.
REFER TO CAUTION STATEMENT #2 ON THE BACK PAGE OF THIS MANUAL FOR IMPOR-
3