Anchor 59 Aurora Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Namiot Anchor 59 Aurora. Anchor 59 Aurora 13 stron.
Również dla Anchor 59 Aurora: Instrukcja instalacji (13 strony)
Drukuj stronę
Raise Center Poles:
8
center poles in the order and manner stated
in the paragraph below. From underneath the
tent, insert the pin of the center pole through
the grommet at the peak and tie jump rope.
Push the pole with the fabric up until the
center pole is approximately half way raised.
Then, when raising to vertical, the bottom of
the pole should be positioned on the mark
made in step one.
•
Raise poles 1 and 2 half way. Proceed to
poles 3 and 4, raise them half way.
•
Go back to poles 1 and 2, raise them all
the way up to vertical.
•
Go to poles 5 and 6, raise half way.
•
Go to poles 3 and 4, raise all the way up.
•
Go to poles 7 and 8, raise half way.
•
Go to poles 5 and 6, raise all the way up.
•
Go to poles 7 and 8, raise all the way up.
Center Pole
Winch for Tension:
9
Straighten the side poles around
the tent so that bottom of poles
are positioned on their respective
marks. Tension guy webs with
ratchets all around tent until poles
are vertical and plumb. Do not
over-tension.
The following tensioning se-
quence is recommended for the
best overall appearance:
1.
Tension webs at the lace lines
fi rst.
2.
Tension webs at the rounded
corners.
3.
Tension webs at the ends.
4.
Tension webs at the valleys
last.
8
Raise
Jump Rope
Caution: It is
required that all
center poles be
properly anchored
as shown to pre-
vent movement.
Rope goes thru
jump rope hole
in center pole
and ties around
stakes.
Caution: Keep to
side of winch when
tensioning. Do not
extend length of winch
tool.
5
7
6
8
Jump Rope
Winch Tool
3
1
4
2