Anchor NAV50-1204 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Namiot Anchor NAV50-1204. Anchor NAV50-1204 18 stron. 50’ wide frame tent system

Drukuj stronę

BFW

& T30

INTRODUCTION:

The NAVI-TRAC frame configuration is based on

the hip roofed square tent shown at right.

Hip bars connect corners to the peak, and rafters

connect eave bars to the peak. The square can

be extended into a rectangle by adding 10', 15'

or 20' bays made up of rafters and the appropri-

ate ridge/eave bars (see above). In the square

tent, female eave bars and rafters are connected

to eave weldments by rigid slip joints. Hip bars

and eave/ridge bars and rafters in the middle

bays use easy to install drop-in fittings.

The NAVI-TRAC frame is made up of extruded aluminum members joined by weldments such as cor-

ner weldments, ridge weldments, eave weldments, etc. The aluminum frame members themselves are

extruded with channels into which the NAVI-TRAC fabric "kedar" is fed.

The first bay added to the square tent shape is a "starter" bay. This starter bay allows a slip fit

connection to the square tent eaves on one end of the weldment and a drop-in connection for the new

starter bay eaves on the other end of the weldment.

Subsequent bays added to the unit are "extension" bays. Extension bays allow drop-in connections on

both ends of the eave weldments.

The chart on page 1 lists components needed for the 50' x 50' square tent, the first (starter) extension,

and for each additional extension to be added to the unit. Note: starter mids or bays and extension

mids are available in options of 10', 15' or 20' increments of length, as shown.

50' Navi-Trac Frame Terminology

EIW

MLW

MCW

ER10

R5-7

R21-9

C50

MRW

EIW

R16-2

H21-4

BFW

& T30

T42

SQUARE TENT

TOP FRAME

ER15

ER20

E10

R5-7

H15

R21-9

EIW

E15

4-B