Anchor Navi-Trac Lite Instrukcja instalacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Namiot Anchor Navi-Trac Lite. Anchor Navi-Trac Lite 20 stron. Frame tent 30' wide system

Installation of Gabled End Fabric Panels

To install the gabled end fabric, first insert one of the wheeled panel guides and bracket on the end beam with the wheels facing out.

Insert the fabric kedar of one half the end into the upper channel and use the push pole to slide the half panel to the peak (fig. 53).

Repeat this from the other side of the structure. Then join the two half panels at the peak using the carabiner to fasten the rings and

lace down the center line using a standard loop and grommet tent lacing pattern.

Attach the web ratchet to the triangular metal ring and to the tension hole in the end upright and ratchet into tension (fig. 54).

TOP CHANNEL

GABLED END

VALANCE

STANDARD LOOP &

GROMMET LACE WITH

WEATHER FLAP.

RIGHT

LEFT

SIDE

UNITS WITH 2 GABLED ENDS -

FRAME SAFETY

A structure with (2) Gabled Ends lacks the initial stability

normally provided by the hip end frame during installation

of the first middle beams. To compensate for this, we have

provided Installation Safety Guys to stabilize the first standing

beam until additional beams are connected.(see fig. 55)

Notice that the first beam raised is actually the second beam

of the frame system (fig. 55). In this way, the first beam

raised can be safely guyed to the base plates of the adjacent

beams on each side.

Next, the first beam of the layout is raised and joined to the

second (fig. 56).

When X-cabling has been installed in this first bay (see fig.

56), the structure is secure for standing the remaining beams

in the same way previously shown for standing middle beams

(fig. 57).