Electrolux EIDW1805KS Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zmywarka Electrolux EIDW1805KS. Electrolux EIDW1805KS 13 stron. Complete owner's guide (français)
Również dla Electrolux EIDW1805KS: Instrukcja obsługi i konserwacji (16 strony), Arkusz danych serwisowych (2 strony), (Hiszpański) Instrukcja obsługi i konserwacji (16 strony), (francuski) Guide D'utilisation Et D'entretien (16 strony)
Drukuj stronę
PREPARE ELECTRICAL WIRING
WARNING
FOR PERSONAL SAFETY: Re-
move house fuse or open circuit
breaker before beginning installa-
tion. Do no use an extension cord
or adapter plus witthis appliance.
ELECTRICAL REQUIREMENTS:
• This appliance must be supplied with 120V,
60Hz., and connected to an individual properly
grounded branch circuit, protected by a 15 or 20
ampere circuit breaker or time delay fuse.
• Wiring must be 2 wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
Grounding Instructions - Cable Direct
This appliace must be connected to a grounded
metal, permanent wiring system, or an equipment
grounding conductor must be run with the circuit
conductors and be connected to the equipment
grounding terminal or lead on the appliance
Grounding Instructions - Power Cord Models
This appliance must be grounded. In the event of a
malfunction or breakdown, grounding will reduce
the risk of electrical shock by providing a path of
least resistance for electric current. The plug must
be plugged into an appropriate outlet that is in-
stalled and grounded in accordance with local
codes and ordianances.
WARNING
The improper connection of the
equipment grounding conductor
can result in a risk of electric
shock. Check with a qualified
electrician or service representa-
tive if you are in doubt that the
appliance is properly grounded.
Installation Preparation
CABINET PREPARATION & WIRE ROUTING
• The wiring may enter the opening from either
side, rear or the floor within the shaded area.
• Cut a 1-1/2" max. dia. hole to admit the electrical
cable. The hole must be free of sharp edges. If
the cabinet wall is metal, the hole edge must be
coveredwith a bushing.
• Cable direct connections may pass through the
same hole as the drain hose and hot water line, if
convenient. If cabinet wall is metal, the hole edge
must be covered with a bushing.
NOTE: Power cords with plug must pass through
a separate hole.
Electrical Connection to Dishwasher
Electrical connection is on the right front of dish-
washer.
• For cable direct connections the cable must be
routed as shown in Figure E. Cable must extend
a minimum of 24" from the rear wall.
• For power cord connections, install a 3-pront
grounding type receptacle. The power-supply
rececptacle for the appliance shall be installed in
a cabinet or on a wall adjacent to the
undercounter space in which the appliance is to
be installed.
4