Formax AutoSeal FD 2052 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyny składające Formax AutoSeal FD 2052. Formax AutoSeal FD 2052 12 stron.

1. To enter the Autobatch mode press the "Batch

Count" button and select "AUTOBATCH" by pressing

the "-" button (Fig 3a).

2. Once you have entered the Autobatch mode press

the "+" or "-" button and "Sheets" (Fig. 3c) will blink.

Press the "+" or "-" buttons to increase or decrease the

number of sheets to be pulled.

3. When the sheet number is set wait 5 seconds and

"Sets" (Fig. 3c) will blink. Press the "+" or "-" buttons

to increase or decrease the number of sets to be

pulled.

4. When the number of sets has been selected wait 5

seconds and "Delay" (Fig. 3c) will blink. Press the "+"

or "-" buttons to increase or decrease the time delay

between the sets.

5.When the settings are correct press the "Start/Stop"

to start.

NOTE: The system will cycle through the settings until

the "Start/Stop" button is pressed.

NOTE: If a fault occurs during a set, the set will be

completed when the fault is reset.

NOTE: The batch counting program selected will

remain on after the job is processed. You must press

the Batch Counting button to turn off the light and

cancel the batch count setting.

DAILY MAINTENANCE

1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding and sealing. This

allows toner to set on the forms, and static electricity to discharge. A 400 Series Jogger is recommended for

best results. The Jogger squares the forms and dissipates heat and static electricity created by laser printers.

2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened sparingly with a

mild household cleaner.

3. Clean in-feed wheels and fold rollers with Formax recommended roller cleaner & rejuvenator to remove

paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use any chemicals

other than the roller cleaner & rejuvenator or water.

Figure 3b

Figure 3c

"Sheets" = Number of sheets of paper in a set

"Sets" = Number of sets to be processed

"Delay" = Time between each set

"C" = Total number of sheets processed