Formax FD 280-10 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyny składające Formax FD 280-10. Formax FD 280-10 16 stron.

4. SET-UP

4.1 Feeder

Assembly

KEEP LOOSE CLOTHING, TIES, SCARVES AND

HAIR AWAY FROM ALL MOVING PARTS. DO NOT

PLACE FINGERS OR TOOLS BETWEEN OR NEAR

MOVING PARTS.

THE FD 280-10 IS A HEAVY MACHINE. USE

PROPER LIFTING TECHNIQUES

The Feeder is shipped disassembled. Carefully remove all

components from its shipping container. Save the

container until you are satisfied that the Feeder is

operating correctly. Report any shipping damages to the

carrier.

1. Screw 4 aluminum risers (feet) to the machine by

inserting the long 10-32 screws through the feet and

the risers, then into the machine. Tighten evenly until

the heads of the screws are fully inside the feet.

2. Remove the screws from the ends of the paper stop

assembly and slide the assembly into the mounting

grooves between the side frames. Line the holes in

the side frame up with the holes in the paper stop and

screw them together.

3. Attach the Tail Support bar to the cross bracket in the

feed hopper.

4. Attach the Output Roll assembly by inserting the spring

loaded end of the rod in the hole closest to the

operator and carefully rotating the flatted end of the

shaft until it lines up with the flats and inserts into the

opposite end. The spring tension holds the roller in

place.

WARNING