Ancona 450 CFM Instrukcje użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla Okap wentylacyjny Ancona 450 CFM. Ancona 450 CFM 6 stron. Wall mount pyramid rim 30 inches

Drukuj stronę

GENERAL INSTALLATION INSTRUCTIONS

PREPARATION

A: GENERAL

 Carefully unpack the hood but do not remove any

protective film until after installation to avoid

accidental damage or scratching. Place filters

somewhere safe for the same reason.

 Check for damage, and lay out the hood pieces and

parts.

 Range hoods do not come with wall or ceiling screws,

as the type of structure determines the type of screws.



Check that you have the right tools. In addition to

marking and measuring tools, a hammer, screwdrivers,

pliers and scissors, you may need sheet metal sheers,

and wire strippers. Safety glasses are recommended.

B: ELECTRICAL CONNECTION

 This range hood must be grounded. If the dwelling

wiring is not 2-wire with a ground wire, a ground must

be provided by the installer.

 Install a 5.08 X 10.16 cm (2" X 4") wall outlet box and

3-blade 125 Volts, 15 amp grounded receptacle.

 Use wire nuts to connect incoming ground, neutral and

hot.

 Push wires into the junction box and replace cover. Be

sure wires are not pinched.

C- INSTALLATION DISTANCE FROM TOP OF

RANGE

 Hood should be placed at a minimum of:

– 61 cm (24") for electric cooking surface

–

76 cm (30") for gas cooking surface