Athom HOMEY-BRIDGE 01 Series Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Bezprzewodowy punkt dostępowy Athom HOMEY-BRIDGE 01 Series. Athom HOMEY-BRIDGE 01 Series 5 stron.
Drukuj stronę
Regulatory Compliance Information
FCC Compliance Statement
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment to an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/ TV technician for help.
Important: Changes or modifications to this
product not authorized by Athom could void
the electromagnetic compatibility (EMC) and
wireless radio compliance and negate your
authority to operate the product.
RF exposure information
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of
exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not
be less than 20cm during normal operation.
This product has demonstrated EMC
compliance under conditions that included the
use of compliant peripheral devices and
properly shielded cables between system
components. It is important that you use
compliant peripheral devices and properly
shielded cables between system components
to reduce the possibility of causing interference
to radios, televisions, and other electronic
devices. This product was tested for EMC
compliance under conditions that included the
use of compliant peripheral devices of several
brands.