Forms + Surfaces COPENHAGEN Instrukcje instalacji

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Meble zewnętrzne Forms + Surfaces COPENHAGEN. Forms + Surfaces COPENHAGEN 2 stron. Bench

Drukuj stronę
COPENHAGEN
MATERIALS INCLUDED
7/32" hex bit for
tamper-resistant
screws
STEP BY STEP
FOR ALL COPENHAGEN BENCHES (SBCOP-78S SHOWN)
Mark hole locations
• Place bench in desired location. Mark
center of each hole location with a
pencil.
T 800.451.0410 | www.forms-surfaces.com
© 2012 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
BENCH
TM
c
a
b
d
e
Drill holes
• Use hammer drill to drill 1-7/8" deep x
1/2" diameter anchor hole at each
marked location using a 1/2" drill bit
suitable for concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 3/16" diameter drill
bit followed by 3/8" and finally 1/2" for
maximum accuracy.
SURFACE MOUNT INSTALLATION INSTRUCTIONS
TOOLS NEEDED
pencil
3/16", 3/8" & 1/2" drill
hammer drill
bits for concrete
steel
wire brush
1/4" punch
a
Insert & set anchors
• Use compressed air and steel wire brush
to clean each anchor hole.
• Insert 3/8"-16 x 1-1/2" anchor (a) into
each anchor hole and use hammer to tap
anchor tops flush with ground level.
• Use 1/4" punch and hammer to set
anchors by driving down the center of
each anchor until it stops.
page 1 of 2 | Rev. 12-17-12
hammer
a