Dreame Vortech Z10 Station Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Odkurzacz Dreame Vortech Z10 Station. Dreame Vortech Z10 Station 13 stron.

Drukuj stronę

time. Allow the vacuum to cool down for

30 minutes before charging it.

• When the vacuum is not in use, it can be

placed on the dust-removal hub.

• The outlet of the power cord can be

adjusted according to users' needs.

Fig. C-1

Battery Status Display

Display Screen

The number on the display screen

represents the current battery level in a

percentage during charging. When the

number becomes 100, the battery is fully

charged.

Fig. C-2

Battery Status Indicator

Charging

Fully charged

Charging

Discharging

Battery Level ≥ 10%

Battery Level ＜ 10%

Solid white

Blinking white

Fig. C-3

How to Use

Display Screen

1. Trigger Switch Lock

Press briefly to enter/ exit the lock state.

2. Suction Level

The color of fan-shaped icon changes

with different modes.

3. Lock Status

4. Battery Level Percentage

When the display shows "LO", it indicates

that the battery level is lower than 10%.

5. Suction Level Switch

Press briefly to switch between eco, med

and turbo mode.

Note: The Med mode is used by default

every time the vacuum is turned on.

Charging/Battery Level Indicator

Low Battery Level

Blinking red: Battery level ≤ 10%

Out of Battery

Blinking red: Battery level ＝ 0%

Charging

Breathing red: Battery level ≤ 10%

Breathing green: Battery level ＞ 10%

Fig. D-1

Suction Level

Med

Eco

Turbo

Fig. D-2

Off

Troubleshooting

If the vacuum is not working properly, the screen display will show an error message.

Please refer to the troubleshooting table to find your solution.

Error Icon

Status

Error Message

Blinking orange

Air duct blocked

Blinking orange

Brush roller stuck

Solid orange

Filter is expiring

High-

Blinking red

temperature

alert

If one of the error codes from E0 to E4 appears on the display screen, please contact the

after-sales service team.

Working Methods

Select from two working methods for the vacuum, which can be selected based on your

own needs.

Method 1: Discontinuous Cleaning Mode

Press and hold the power button to start the appliance, and release the button to stop

immediately.

Fig. D-3

Method 2: Continuous Cleaning Mode (Trigger Switch Lock)

Press the trigger switch lock to switch to Continuous Cleaning Mode, and then briefly

press the power button to keep the vacuum in Continuous Cleaning Mode.

Note:

• Use the trigger switch lock to free your fingers from fatigue caused by holding the

switch.

• Press the trigger switch lock again to quit Continuous Cleaning Mode.

Fig. D-4

Solutions

Check whether the dust cup,

extension rod, multi-surface brush,

soft roller brush or motorized mini-

brush is blocked.

Refer to the [Cleaning the Multi-

Surface Brush] section to clean the

debris and hair tangled on the brush

roller.

Please replace the filter in time.

Please wait until the motor

temperature returns normal.