ATI Audio DA2008 Instrukcja obsługi i konserwacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Wzmacniacz ATI Audio DA2008. ATI Audio DA2008 6 stron.

ATI Audio DA2008 Instrukcja obsługi i konserwacji
OUTPUTS
Audio from the input buffer is AC coupled to the front panel level adjusts
potentiometers.
The pot outputs are applied to the non-inverting input of the HI (in-phase) output
stage driver ICs. The ICs supply the first 10 ma of output current directly and
then complementary Class B output booster transistors take over. The unique,
wide bandwidth, high slew rate circuit design provides effective class AB
operation with minimal crossover distortion from a power output stage operating
true Class B with zero quiescent power dissipation.
The HI output bus is inverted and boosted to drive the LO output bus.
The HI and LO output buses of each channel are split into four individual
balanced outputs through 150 ohm build out resistances. All outputs will tolerate
short circuits across the output or to the ground without damage. Up to two
outputs can be shorted with no significant reduction in headroom. Needless to
say, this is NOT the recommended mode of operation. Do not drive a LO output
into the grounded end of an unbalanced load. Drive single ended loads from
either the HI or LO output to ground. Up to 16 single ended 600-ohm output
loads may be simultaneously driven by our Micro DA.
The build-out resistors are split and heavily bypassed to prevent RF pickup on
the output lines from affecting operation of the DA. These bypasses will place a
very heavy load on the outputs under sustained sine wave operation above
20kHz and such operation may over dissipate the 47 ohm build-out resistors—
don't do it!
OUTPUT CLIPPING INDICATOR
The differential input voltage of each HI output driver IC is monitored by a section
of A3. The differential voltage is under a few millivolts under linear operation,
however, if the output is driven to clipping the differential voltage rapidly
increases and is amplified to light the yellow OUTPUT CLIPPING LED. Conserve
power—try not to light the yellow LED.

HEADPHONE OUTPUT

The front panel headphone jack is a convenient metering point, an auxiliary
output or headphone output. The jack is wired to drive stereo headphones with
channel A to the tip and channel B to the ring. The sleeve connection is wired to
ground. The jack is isolated by 470-ohm build out resistors.
Day Sequerra │ 154 Cooper Rd. #902 │ W. Berlin, NJ 08091 │ Voice 856-719-9900 │ [email protected] │ www.atiaudio.com