ATI Audio MCDA-208/WC106 Instrukcja obsługi i konserwacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Wzmacniacz ATI Audio MCDA-208/WC106. ATI Audio MCDA-208/WC106 13 stron. Ultra-low-jitter studio master clock with dual 1x4 aes/ebu distribution amplifier and 1x6 clock distribution amplifier
Drukuj stronę
FRONT PANEL DISPLAYS AND SWITCHES
POWER
Indicates that the MCDA is powered and power switch is on.
INPUT FAULT
Indicates loss of carrier on any of the four inputs, INPUT 1 (AES 1), INPUT 2 (AES 2), AES SYNC-IN
(AES SYNC) or WORD CLOCK INPUT (WCLK).
CLOCK SOURCE SELECT
Selects timing reference source for clock generator. Sequentially pressing the Clock Source Select
button selects from External AES Sync (AES SYNC-IN), External Word Clock Input (WORD CLOCK
INPUT), or Internal crystal reference. An additional button press illuminates the BY PRIORITY LED and
enables automatic priority selection of timing reference source in the order: AES External Sync,
External Word Clock In, or Internal. Selection is enabled only when Source Monitor & Control WCLK
LED is on.
INPUT TERM
Indicates whether the input termination is on or off for the source selected by the Source Monitor &
Control switch. Press the INPUT TERM button to toggle the setting. Settings are individual for each
source selected, and are memorized and retained through power outages.
OUTPUT CLOCK FORMAT
Indicates either Word Clock or Super Word Clock format available at outputs. Press the SELECT button
to toggle the setting. Enabled only when WCLK LED is on.
SAMPLE RATE
When Clock Source Select switch is set to INTERNAL and the WCLK LED is on, the SAMPLE RATE
switch selects the internal generator sample rate. For manual Word Clock sample rate selection, set
Source Monitor & Control to WCLK LED on. When the Clock Source switch is set to EXTERNAL AES
SYNC or EXTERNAL WORD CLOCK IN, the LEDs indicate the sample rate of the external input from
32 kHz through 192 kHz.
WORD LENGTH
Indicates the Word Length of the input signal from 16 through 24 bit.
DIGITAL ERRORS
Indicates four error conditions encountered in digital signals as an aid to troubleshooting: Bi-
Phase/Parity, Validity, Non-Linear PCM and DTS-CD Signal.
6
MCDA‐208/WC106 Manual