Carmanah E Series Instrukcja wymiany - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja wymiany dla Panel słoneczny Carmanah E Series. Carmanah E Series 9 stron. Rrfb mast arm kit
Również dla Carmanah E Series: Skrócona instrukcja obsługi (20 strony), Instrukcja instalacji (16 strony), Podręcznik wymiany systemu zarządzania energią (12 strony), Instrukcja instalacji (20 strony), Podręcznik użytkownika (18 strony), Instrukcja instalacji (18 strony)

Legacy Systems (R920/R247-E) – Horizontal Opening Engines Only

3.2

1. For legacy systems that open horizontally the replacement panel will need to be modified. Drill and tap

two holes (one on each side of the panel) as shown with the supplied 0.136" drill and #8-32 tap.

a. Alternatively, simply mark the hole locations while holding the solar panel in place within the

engine, then drill and tap the holes in the panel extrusion.

2. Plug the two open holes in the top of the solar panel with two 1/8" sealing rivets.

3.3

1. Drill out the solar panel hinge rivets on each side of the metal enclosure then remove the solar panel. Pull

on the side of the enclosure to allow the old rivets ends to come free from the enclosure. Ensure the rivet

holes aren't enlarged from drilling the rivets.

2. For vertical opening systems solar engines, drill out the rivets shown below to remove the top cap from

the damaged solar panel. Ensure the rivet holes aren't enlarged from drilling the rivets. Reuse the top cap

and attach it to the replacement solar panel using two 1/8" rivets.

a. For F Series engines there will be a third rivet near the center on the top cap that needs to be

drilled out as well.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

Drill and tap

these two holes

Drill these rivets

out

SOLAR PANEL REPLACEMENT GUIDE

Pre-drilled

carmanah.com