Advanced Keys AK-PSB05 Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Advanced Keys AK-PSB05. Advanced Keys AK-PSB05 15 stron. Push-start ignition system

Drukuj stronę

FAQ

How does Push-Start Ignition work and how do I know it is working normally?

Why is the Push-Start button dead / not working?

Check system's input power and make sure there is a proper signal applied to "Push -Start Enable"

input depending on Jumper 2 (JP2) setting. Amber Status LED indicates system is Ready.

The Push-Start will activate ACC and ON, but engine would not start/crank when I START?

1. Before START, make sure button Status LED is flashing Amber light when brake is applied.

2. Make sure shifter is in Park or Neutral position.

3. If this is a manual transmission vehicle, the clutch will need to be bypassed.

4. Check voltage and for open fuses on the main 8-pin harness Battery 12v+ inputs.

5. Make sure the starter wire is connected on the starter side of the optional starter kill relay

6. Check connections. Make sure that all harnesses connectors are fully plugged into the module

with no back-out pins and it is making solid connections to the vehicle wiring.

The vehicle starts, but immediately stops:

during unauthorized START and it needs to be bypassed.

2. Is the system programmed for Tach Ignition? If so, reprogram Tach as signal maybe too low. See

IGNITION TEST AND TROUBLESHOOTING section for more info.

3. Is the system programmed for Tachless Ignition? If so, make sure button is pressed long enough

to allow engine to run on its own.

The vehicle starts, but the starter over / under crank when start:

shown in the IGNITION TEST AND TROUBLESHOOTING section.

to ground leading to the system.

3. Is an ignition or accessory output wire connected to the starter wire of the vehicle? Verify the

color of the starter wire in the vehicle and confirm that an ignition or an accessory output is not

connected to that wire.

Why is the system turns the Ignition ON every time I connect power to it?

As a safety feature to prevent power sag/flash or sudden loss of power while system is running

(RUN mode), it will default back to RUN Mode when power is resumed. To exit RUN mode, apply

the brake and press and hold the button for 2+ sec to switch back to READY or OFF mode.

Why is button status LED flashing Green/Red when attempt to crank the engine?

Check battery, there is not enough power to crank engine and keep system running at the same

time. System required minimum 10v to operate and if voltage drops below 10v while starter is

engaged it will effectively turn OFF the system. This cause the Ignition/Start to drop out

simultaneously. Status LED flashes Green/Red to indicate system is initializing/rebooting after

power has been restored.

Why is my push button turn flashing green after started?

System failed to sense Tach during start and defaulted back to IGNITON ON Mode. Turn vehicle

OFF first by press push-start button once (DO NOT APPLY BRAKE). Verify Tach signal output

from the vehicle and perform Tach Ignition programming.

If engine is running DO NOT attempt to START again. (Press the Push-Start

button while brake is applied) This will cause the engine to over crank.

WARNING

-Start Ignition Sequence and follow