Andersen 18ST FS Instrukcja obsługi produktu - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Wyciągarki Andersen 18ST FS. Andersen 18ST FS 8 stron.
Również dla Andersen 18ST FS: Podręcznik (9 strony)
Drukuj stronę
MOUNTING INSTRUCTIONS
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the
position numbers in the parts list.
Tools required for the installation:
• Allen key (3 mm)
• Allen key (5 mm)
• Ø6.5 mm. (1/4") drill
• Bedding compound
1. Remove screws (1).
2. Remove self-tailing arm (2) and drum (4).
3. Place the template and drill holes Ø6.5mm (1/4").
Make sure that no dust comes into contact with the winch while drilling.
4. Apply a light coat of bedding compound, ensuring that each bolt hole is bedded.
Keep drain grooves clear.
5. Fasten base (14) into place using 6 pieces. M6 (1/4") countersunk head screws.
Use large washers or a backing plate.
6. Assemble in reverse order.
7. Check that the winch is functioning correctly:
- The drum should operate smoothly, by turning the drum clockwise by hand.
- The drum must not turn when trying to turn the drum anti clockwise.
- While turning the winch handle clockwise the drum should turn.
- While turning the winch handle anti clockwise the drum should not turn.
PAWL SPRING MOUNTING
Note the curved
spring "arm"
18ST (V.2.0)
18ST FS (V.2.0.F)
• 6 x M6 (1/4") countersunk head screws and corresponding
nuts (length depending on deck thickness).
• 6 x large washers or backing plate
• Ring spanner to match nuts
p4