Andersen 34ST FS Instrukcja obsługi produktu - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Wyciągarki Andersen 34ST FS. Andersen 34ST FS 8 stron.

MOUNTING INSTRUCTIONS

Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the

position numbers in the parts list.

Tools required for the installation:

• Allen key (4 mm)

• Allen key (5 mm)

• Ø6.5 mm (1/4") drill

• Bedding compound

1. Remove screws (1).

2. Remove self-tailing arm (2) and drum (4).

3. Mark location of boltholes using the template.

IMPORTANT: On the 34ST the self-tailing arm (2) is fixed in one position.

Ensure correct positioning of the self-tailing arm, before marking the bolt holes.

Drill bolt holes Ø6.5mm (1/4"). Be sure that no dust comes into contact with the winch

while drilling.

5. Apply a light coat of bedding compound, ensuring that each bolthole is bedded.

Keep drain grooves clear.

6. Fasten base (15) into place using 5 pieces. M6 (1/4") countersunk head screws.

Use large washers or a backing plate.

7. Assemble in reverse order.

8. Check that the winch is functioning correctly:

- The drum should operate smoothly, when turning the drum clockwise by hand.

- The drum must not turn when trying to turn the drum anti clockwise by hand.

- While turning the winch handle clockwise the drum should turn slowly.

- While turning the winch handle anti clockwise the drum should turn quickly.

PAWL SPRING MOUNTING

Note the curved

spring "arm"

34ST (V.2.0)

34ST FS (V.2.0.F)

• 5 x M6 (1/4") countersunk head screws and corresponding

nuts (length depending on deck thickness)

• 5 x large washers or backing plate

• Ring spanner to match nuts