Andersen 40 ST FS Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Wyciągarki Andersen 40 ST FS. Andersen 40 ST FS 6 stron.
Również dla Andersen 40 ST FS: Podręcznik (9 strony), Instrukcja obsługi produktu (8 strony)
Drukuj stronę
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position
numbers in the parts list.
Tools required for the installation:
Screwdriver (large).
Ø6,5 mm. (1/4") drill.
5 pcs. M6 (1/4") countersunk head screws.
Ring spanner to match nuts.
1. Drill bolt holes Ø6,5mm (1/4") using the winch template. Be sure that no dust comes in
contact with the winch, while drilling.
2. Remove screw (1) and top cap (2).
3. Remove selftailing arm (3) and drum (5).
4. Apply a light coat of bedding compound on the bottom of the base (20). Ensure that each bolt
hole is bedded. Keep drain grooves clear.
5. Fasten base (20) into place using 5 pcs. M6 (1/4") countersunk head screws. Use large
washers or a backing plate.
6. Assemble in reverse order.
7. Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle clockwise the drum should turn fast.
While turning the winch handle anti clockwise the drum should turn slowly.