Andersen 40 STE Podręcznik - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik dla Wyciągarki Andersen 40 STE. Andersen 40 STE 17 stron. 2+1 speed
Również dla Andersen 40 STE: Podręcznik (8 strony)

Drukuj stronę
Andersen 40 STE Podręcznik
28STE Compact & 2+1 SE
These instructions will guide you through the
procedures to prepare your winch for use with an
ANDERSEN Compact/ 2+1SE motor. This involves
changing the bottom ratchet gear so that the winch
can be coupled to your new motor. Winches older
than November 2002 will also require a new winch
base (supplied with your motor).
Remove your winch from the boat and find a clean
and stable spot to work on your winch. As you
disassemble your winch, as described below,
carefully clean each part with degreaser. While reassembling apply a thin layer of
Andersen Winch Grease to all moving part.
Tools: Flathead screwdriver, winch-handle and ANDERSEN Winch Grease. (Newer
winches require a 4mm Alan key)
1. Loosen the screw on top of the winch and remove the drum.
2. Remove the shaft by pulling it upwards, twisting it as you go. A winch handle can be
helpful. You can then remove the top ratchet gear.
3. Remove the shaft ring and the roller bearing by sliding it up over the winch base.
You can then remove the gear wheel.
Page 2 of 17