Advanced Kiosks Outdoor Monolith Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Digital Signage Advanced Kiosks Outdoor Monolith. Advanced Kiosks Outdoor Monolith 20 stron.

anchors. Make sure the hole is always drilled 1/2" deeper than the depth the sleeve

anchor will penetrate into the base material.

3. Also drill 2 holes for the drainage hoses. These should go into the ground in a way that

allows the water that accumulates to drain, either through soil, or through channels. The

holes should be about ¾" and sealed with silicone or gasketing.

4. Clean the hole of all debris made during drilling, using a brush, vacuum, or compressed

air. Debris can prevent secure mounting. Center kiosk over drill holes.

5. Sleeve anchors come fully assembled with a nut and washer. It is important that the nut is

on the end of the threads to protect the threads during hammering. For the ¾" sleeve

anchors mounted to the base of the kiosk, the minimum embedment depth is 2 and 1/4"

deep into concrete. We recommend at least 1-2 inches deeper, just in case. See the

specifications on the next page for reference. These general specs may differ based on

your location, as these are for concrete.

Sleeve Anchor General Specs from

6. Insert the sleeve anchor through the 6 mounting holes and into the hole you drilled in the

floor material. A hammer will be required to pound the sleeve anchor into the material

until the washer and nut are tight against the base.

7. Tighten the nut until finger tight, always turning clockwise. Using a wrench or socket,

use 60-90 ft/lbs. of torque as specified above.

8. Now after the base has been firmly and securely affixed to the ground, lift the kiosk

enclosure on top of the base, and precisely line up the holes with the base bolts. Use the

lifting rings on the top of the kiosk with a lifting system. Do not try and lift by hand.

Use extreme caution to prevent injury.

Outdoor Monolith Kiosk Assembly and Operation Instructions

https://www.concretefasteners.com/technical-

specifications-for-sleeve-anchors/

www.advancedkiosks.com

12/16/2020