Andersen 400 Series Regulacja - Strona 2

Przeglądaj online lub pobierz pdf Regulacja dla Zamki Andersen 400 Series. Andersen 400 Series 4 stron. Lock mechanism
Również dla Andersen 400 Series: Instrukcja instalacji i demontażu (2 strony), Skrócona instrukcja obsługi (6 strony), Podręcznik zmian (2 strony)

NOTICE

• Hinge replacement WILL NOT correct problems

resulting from improper door installation

Examples of improper installation include units

not being installed plumb, level, and square,

excessively bowed jambs, and/or crowned sills.

Hinge Replacement

Door Panel

Remove screws from hinge using a phillips screwdriver. Dispose of hinge and screws properly.

Door Panel

Frame

Apply replacement hinge and fasten to frame using two (2) #10 x 1" screws through top and

bottom holes and two (2) #10 x 3" screws through center holes.

▶ Hinge replacement is complete.

▶ Proceed to hinge and hardware adjustment, below, for operation check and hinge adjustment instructions.

0 0 05 41 3

Remove and replace only one

hinge at a time. Removal of more

than one hinge may result in door

panel falling and potentially

causing personal injury, product,

and/or property damage.

Frame

#10 x 1"

Screws

(top and

bottom holes)

Door Panel

• Make all horizontal adjustments first. Horizontal adjustments correct

most problems. Vertical adjustments are rarely needed.

• Adjust hinges with door slightly open. The door panel should be

supported by all hinges for maximum hinge performance.

• Start adjustments at bottom hinge and move upward.

WARNING

#10 x 3"

Screws

(center holes)

Frame

IMPORTANT

#10 x 1-3/4"

Screws

Door Panel

Fasten hinge to door panel using four (4)

#10 x 1-3/4" screws. Repeat steps 1-3

for all hinges being replaced.

Frame