Carnation CR2300 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Licznik gotówki Carnation CR2300. Carnation CR2300 6 stron. Bank-grade bill counter

CARNATION

this function is active. The counter will check the ultra-violet feature of the

counted banknotes.

3. Magnetism function

Press the CF button, when the MG symbol on display is light on, which means

this function is active. The counter will check the magnetic ink of the counted

banknotes.

4. Banknote Width Detection

The machine will stop and beep if it encounters a shorter banknote in the

batch of same size banknotes, and "EE4" code will be displayed. The

suspicious banknote is the top banknotes in the banknote stacker.

Feeder Adjustment

The adjusting screw of the feeder aperture on the back cover has alre-

-ady been set at the factory. You may need to adjust the feeder aperture if

the following problems occur during counting:

Frequent jams, or banknotes pass the feeder

with difficulty - turn the adjusting screw counter-

clockwise to make the aperture wider.

Frequent "EE5" or "EEA" error message

turn the adjusting screw clockwise to make the

aperture smaller.

The adjusting screw is very sensitive, move only one notch at a time!

loosen

Tighten

Wider the aperture Smaller the aperture

CARNATION

Note! When "EE7" code is displayed, the

banknotes have not been placed in the

hopper properly. Please redo it.

1.The resistance piece needs to be replaced

when worn. Pull out the banknote feeder,

press the banknote sliding board down,

and replace the worn resistance piece.

2. In case machine doesn't turn on, check the

fuse. The fuse cover is located under the

power cable socket.

1.If operated at temperature below 68℉(20℃), please allow three minutes for

warm-up.

2.The machine must be operated in a well-ventilated area. Keep it away from

direct sunlight and strong magnetic fields.

3.Do not apply oil to machines rubber parts, as it may cause malfunction.

4.Clean all sensors and magnetic head with brush at least once a week.

Fuse holder