Community C4 Instrukcja instalacji i obsługi - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Głośniki Community C4. Community C4 20 stron. 4.5", 6.5", 8" full-range c series coaxial ceiling loudspeakers
Również dla Community C4: Instrukcja instalacji i obsługi (16 strony)
Drukuj stronę
Dry-Wall Ceiling Installation.
There are three basic ways to install a Com-
munity Commercial Design Series loudspeak-
er assembly into a drywall ceiling (a.k.a. sheet
rock or gypsum board). Some are for new
construction, others for retro it to existing
construction. We recommend some methods
over others and of course the choice is yours.
A.
The preferred method for new in-
stallations is to use the optional New Con-
struction Bracket, pre-installing it directly
to the supporting beams before the sheet
rock is applied. Multiple small holes on
wings to either side of the main cutout hole
allow the installer to use screws or nails
to secure the ring to the straddling beams.
See the following subsection for step-by-
step details and variations.
B.
An alternative method for new
installations – where the ceiling has
already been completed – is to use the Tile
Bridge Support Rails. While there are in
fact no truss members across which the
rails it, nonetheless they will distribute
the weight of the loudspeaker assembly
across a greater area and will thus avoid
sagging or having the mounting clamps cut
into the ceiling that might otherwise occur
over time. You can cut the hole using the
provided template or using a New Con-
struction Bracket as a cutting guide, even
though this bracket won't be used for the
actual installation. It's then easy to pass
Community Commercial Design Series
the Tile Bridge Support Rails through the
cutout, then the Spacers, and align the
loudspeaker mounting clamps so they
rest top of the rails. Refer to Figure 15 on
page 14 and to Figure 16 here.
Figure 16. New Installation in an Existing
Use the Tile Bridge Support Rails & Spacers
C.
Retro it an entire Community
Commercial Design Series Loudspeaker
Assembly into an existing oversized ceiling
cutout using a corresponding Commercial
Design Series CATR Can Adapter Trim Ring.
Important! Do not mount the
loudspeaker into any material
without using either the New
Construction Bracket or the
Bridge Support Rails!
Installation and Operation Manual
Drywall Ceiling
Page 15