Community CS6 Instrukcja instalacji i obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Głośniki Community CS6. Community CS6 12 stron. 6.5" full-range surface mount loudspeaker, c series
Drukuj stronę
Installation
IMPORTANT: Community does not provide
hardware for mounting the wall mount plate
to the install surface. This hardware is
customer supplied and subject to local codes and
requirements. It is strongly recommended that a
licensed and certified professional structural
engineer approve the mounting. Severe injury and/or
loss of life may occur if this product is improperly
installed. The provided mounting yoke may not be
suitable for all mounting orientations or
environmental conditions.
1. Attach wall-mount plate to mounting surface
using customer supplied hardware. (See
above). Install the mounting plate to ensure
correct cabinet orientation.
2. Insert the M8 bolt through the lock washer,
flat washer, and the hole on pinch plate.
3. Sandwich the yoke between the pinch plate
assembly and align with the wall plate.
4. The yoke arm should rest inside the notches
on the mounting plate. Lightly finger-tighten
the M8 bolt to loosely hold the yoke assembly
together. (NOTE - Do not tighten the yoke
bolt until final aiming is complete.)
5. Prior to lifting the loudspeaker into place,
complete the wiring preparation (details on
page 7).
NOTE: All electrical and mechanical
installation connections for loudspeaker
lines are subject to all applicable
governmental building and fire codes. The
selection of appropriate electrical and mounting
hardware to interface with C SERIES Surface Mount
Loudspeakers lies solely with the installation
professional. Community recommends that an
appropriately licensed engineer, electrician, or
other professional identify and select the
appropriate conduit, fittings, wire, etc. for the
installation.
C SERIES Surface Mount
Pinch Plate
Installation and Operation Manual
Vertical Loudspeaker Orientation
(Wall mount plate is horizontal)
8mm Flat Washer
8mm Locknut
Wall Mounting Plate
Figure 1. Yoke / wall mount assembly
Horizontal Loudspeaker Orientation
(Wall mount plate is vertical)
1.97in
50mm
1.02in
26mm
13mm
.51in
Wall Mounting Plate Detail
M8 x 25mm Bolt
Yoke
7mm
.28in
31mm
1.22in
62mm
2.44in
86.5mm
3.41in
Page 5