CARNES VCDD040I Instrukcje - Strona 3

Przeglądaj online lub pobierz pdf Instrukcje dla Wentylator CARNES VCDD040I. CARNES VCDD040I 4 stron. In-line ventilators

Drukuj stronę
CARNES VCDD040I Instrukcje
MOUNTING OPTIONS
¼-20 hex nuts secure mounting brackets to housing. Loosen and
re-tighten or remove and replace nuts as necessary for desired
mounting bracket position.
y
yyy
21½"
Mounting brackets in
factory-shipped position.
(Outlet parallel to joists.)
(New construction)
yyy yyy
12¼"
Mounting brackets mounted
to outlet sides of housing.
(Outlet perpendicular to joists.)
(New construction)
yy
yyy
21½"
Mounting brackets mounted
to top of sides of housing.
(Outlet parallel to joists.)
(New or existing construction)
WIRING OPTIONS
WIRING PLATE
POSITION
HORIZONTAL POWER
CABLE CONNECTION
Wiring plate mounts to side or top of housing.
PPP
PPP
yyy @@
PPP
@@@
PPP
@@@
PPP
@@@
PPP
@@@
@@@
@@@
yy
@@
PP
@@
PP
PP
PP
PP
@@
@@
PP
@@
yyy
PPP
PPP
@@@
PPP
@@@
PPP
@@@
PPP
@@@
PPP
@@@
@@@
1
1
/
"
8
MAX.
yy
21½"
Mounting brackets flipped
over and mounted to outlet
sides of housing.
(Outlet parallel to joists.)
(Existing construction)
y
21½"
Mounting brackets flipped
over to give approx. 1"
more clearance.
(Outlet parallel to joists.)
(New construction)
9
1
/
" to
2
10
1
/
"
2
yy
21½"
Mounting brackets flipped
over and mounted to top of
sides of housing.
(Outlet parallel to joists.)
(New or existing construction)
VERTICAL
CONNECTION
®
DUCTING OPTIONS
BLOWER DISCHARGE POSITIONS
DUCT CONNECTOR
1½"
to
yyy
2½"
1
1
/
"
BLOWER
2
to
2
1
/
"
2
Blower and duct connector
yyy
in straight-through dis-
charge position. (Factory
DUCTING (Right angle blower discharge)
10"
10
3
/
" to
ROUND
4
11
3
/
"
DUCT
4
yyy
Typical ductwork connection to a ventilator converted to
USE AND CARE
Ventilator is designed for continuous operation. If desired, it may be
controlled using an on/off switch or a solid-state, variable speed
control. Follow wiring instructions packed with control, and adhere
to all local and state codes, and the National Electrical Code.
POWER
CABLE
To clean blower assembly: Remove access panel, unplug blower
from housing, remove blower mounting nuts, and carefully remove
blower from housing. Use appropriate vacuum attachment or a soft
cloth and mild soap or detergent to clean blower discharge area
and wheel. DO NOT ALLOW WATER TO ENTER MOTOR. Make
sure blower assembly is completely dry before reinstalling.
Motor is permanently lubricated. Do not oil or disassemble motor.
VCDD040I • VCDD050I • VCDD070I
Change
blower
& duct
connector
positions for
right angle
discharge.
shipped)
ROOF CAP
right angle discharge.
WARNING: To reduce the risk of electric shock,
disconnect from power supply before servicing.
MODELS
Page 3
DUCT CONNECTOR
BLOWER
Blower and duct connector
in right angle discharge
position.
4½" X 18½"
TO 10" ROUND
TRANSITION