ATIGO A3200 Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System interkomu ATIGO A3200. ATIGO A3200 7 stron. 2-wire audio system

Drukuj stronę
Audio module A3200
1. SET
DIP switches for system configuration.
2. JP-LK
Jumper for setting state of the NO contact
3. CN/KMB
Call button module A2400 connection port
4. CN/T-COIL
Not in use
5. BUS
L1, L2 bus line connecting to terminal
BUS(DS) on the power supply
6. CN-LK
+12V
12VDC power output.
LK-
Power ground.
LK+
Common contact of the relay.
NO
Normally open/closed contact (use
JP-LK jumper to set)
EB+
Exit button connection port.
EB-
Exit button connection port.
7. CN/FUN
Not in use
8. CN/WGN
Not in use
3 |
P a g e
DIP switch settings for A3200
The audio module is configured by 6 DIP
switches.
The DIP switches can be modified either
before or after installation. Restarting the
Audio module is necessary whenever the DIP
switches have been modified.
DIP switches 1 and 2 are for addressing door
station(s).
When multi door stations are installed on the
system, these two DIP switches must be set
correctly.
Door station DIP switch setting:
No.1 = 00 (Default setting)
No.2 = 10
No.3 = 01
No.4 = 11
DIP switch 3 needs to be set to 0 for
mechanical call button operation.
DIP switch 4 is for call button automatic
allocation. Call buttons are automatically
assigned to the indoor unit. The default setting
for this DIP switch is 0
DIP switch 5 is for setting door unlock time. 0
is the default setting for one second delay and
1 is the setting for five seconds delay.
DIP switch 6 is for activating keys A and B
which are used for programming audio module
functions.
The default setting for this DIP switch is 0.