Andersen Windows & Doors 901724 Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt do zwalczania owadów Andersen Windows & Doors 901724. Andersen Windows & Doors 901724 14 stron. 1-1/2” self-storing storm doors with balanced retractable insect screen and integrated close system

Drukuj stronę
5/8"
TROUBLESHOOTING
5/8"
(Left Hand)
12
For additional help with these,
or any other installation steps,
1 1/2"
please call our Solution Center
at 1-800-933-3626.
1 1/2"
a
J
If your bottom spacer falls off or is out of
position prior to fastening the door the the
mounting surface:
1.
Hook the clip on to the sweep
2.
Rotate clip until it snaps over back of sweep.
3.
Slide clip until it is touching sweep screw on
handle side of door.
d
X
VIEW
If the glass area behind the sill glass filler strip at bottom of door needs cleaning:
1.
With a small hook shaped object like a hex wrench, slide the hooked end into the
slot at either end of the glass filler strip and rotate so hook is under the strip.
2.
Lift up and remove the glass filler strip from the channel allowing access to clean
the glass and channel below the filler.
3.
Align the slot in the corner of the glass and tip the glass filler strip back into place.
Tools needed:
1/2"
2"
1/8"
!
i
b
VIEW
B
5/8"
5/8"
If handle binds or doesn't spring back:
1.
Slightly loosen trim plate screws (A).
2.
Test handle set. If handle moves freely,
1 1/2"
you're done.
3.
If it still binds: Slightly loosen key cylinder
and lock case plate screws (B).
1 1/2"
13
1/2"
1/2"
1"
!
i
VIEW
A
1/2"
If door isn't latching onto latch rail:
1.
2"
2.
3.
4.
5.
6.
c
Remove screw cover from latch rail (if
installed).
Remove six 1" screws from latch rail.
Push latch rail toward door frame until latch
falls into opening in latch rail.
If you can see holes in mounting surface
through holes in latch rail, you will need
to drill new holes in latch rail. Use 1/8" drill
bit to drill holes 1" above or below existing
holes.
Fasten latch rail to mounting surface using
six 1" screws.
Reinstall screw cover (see step 5c).
X
VIEW
1/2"
1/2"
1"