Community Point Source 600 Instrukcja instalacji i obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Głośniki Community Point Source 600. Community Point Source 600 17 stron. I series
Drukuj stronę
CONNECTIONS AND INSTALLATION
USE THE CORRECT WIRE OR CABLE
All I SERIES loudspeakers are fitted with captive-clamp terminal blocks on the
input panel to connect to the amplifier. Terminating the wires with a spade or
ring connector (Figure 1.) is recommended for secure connections. The maximum
width of the ring or spade lug should be 0.375" (9.5mm), or less. The terminal
screws are #8 (M4). The maximum wire size that can be accommodated for bare
wire connections is 10 AWG (5.26 mm
Note: Wire insulation colors may vary depending upon region or manufacturer. Be consistent with
conductor color use throughout the system.
Weather-resistant I SERIES models are ordered preconfigured for passive or
biamp/triamp operation and have a 12' (3.6m) 14 ga cable passing through a
sealed gland nut and input panel cover. Do not remove the gland nut or input
panel cover as this will defeat the weather-resistance of the connection. If you
must remove the input panel or gland nut, it must be reattached and resealed
with a silicone or other similar sealant to maintain the weather-resistance of the
loudspeaker.
CONNECTION: LOUDSPEAKER INPUT PANEL
The input panels on the two-way loudspeakers can be wired in passive or biamp
configurations. The three-way can be wired in biamp or triamp modes. The dual
subwoofers can be wired in single amp or dual amp modes. The input panels
on these models have a jumper that must be placed correctly in order for it to
function in the designated mode. See Figures 2a-2d for the jumper positions.
PASSIVE
Jumper down for Passive operation. Jumper up (or removed) for Biamp operation.
Page 6
).
2
Figure 2a. Two-way input panel
BIAMP
Quick Start Guide
Ring
terminal
Spade
terminal
Figure 1. Wire Connectors
IMPORTANT: All electrical
installation connections for
loudspeaker
subject
to
all
governmental
building
codes. The selection of appropriate
electrical hardware to interface with
the I SERIES loudspeaker lies solely
with the installation professional.
Community recommends that an
appropriately
licensed
electrician,
or
other
professional identify and select the
appropriate conduit, fittings, wire,
etc. for the installation.
I SERIES IP800/IP600, IS800/IS600
lines
are
applicable
and
fire
engineer,
qualified