Anderson 52G1200 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Palnik Anderson 52G1200. Anderson 52G1200 8 stron.

However, it is not necessary to purge when the temperature is higher than 750°C. Oxygen pipe

or gas pipe connected with burner should be tight enough with no leakage, also the periodically

check air or fuel nozzles of the burners to prevent to be blocked by dust, slag or other materials.

ATTENTION：DANGER OF BEEN BURNT

When burner in operation, combustion is severe, so the burner must be fixed. Hoses or cables in

area of the combustion system must be suitable for high temperature, to prevent high

temperature failure or cause safety accidents. Burners should be periodically inspected and

cleaned. Copper wire brush may be used, if necessary, to clean burner head. The burner system

should be checked twice a year for safety operation.

4. Description

FFO – FlexFire® oxygen burner is a trademark of Anderson Thermal Solutions (Suzhou) Co., Ltd.,

it is designed for oxygen firing glass furnace.

FFO52 - Oxygen FlexFire® burner with wide flat flame coverage and high flame brightness; It is

one of the ideal burners for glass melting.

–

When the burner stops for more than 20 minutes, remove the burner

and seal the burner block opening. Prevent burner damage.

–

To adjust the burner, loosen fixing T-bolts and lock it again after the

adjustment is completed

–

Do not remove the metal gas hose or locking device when the gas is not

completely shut down

Anderson Thermal Soluions（Suzhou）Co., Ltd

Anderson Thermal Solutions – FFO52 Burner Operation Manual

Figure 1: FlexFire®52 Oxygen Burner

Attention!