CAROL BTM-311RH Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Mikrofon CAROL BTM-311RH. CAROL BTM-311RH 9 stron.

Drukuj stronę

BTM-311RH Bluetooth Amplifier

3.4 Bluetooth Receiver Operating Instruction:

3.4.1 BTM-311RH built a Bluetooth Receiver (RX) in for receiving signals from computers, cell

phones, and our BTM-210C/D Bluetooth Series.

3.4.2 Devices used to connect with BTM-311RH, such as a computer or cell phone, must be

equipped with a Bluetooth transmission function. Please refer to your device's docu-

ment.

3.4.3 This Bluetooth Receiver can only work with ONE Bluetooth device at a time.

3.5 Bluetooth Receiver Operating Instruction

3.5.1 When the Bluetooth Receiver function is needed, press the Bluetooth "Pair" Button (for

about 3 seconds) when the BTM-311RH is on until the Bluetooth Connecting LED lights

up (as shown in Figure 3.5).

( Figure 3.5 )

3.5.2 Bluetooth Connecting LED signals

Module

Bluetooth Receiver On

Bluetooth Device Scanning

Sound Transmission

Bluetooth Receiver Off

LED signal

Green blinks twice every second

Green and Red blink in turn every second

Green blinks once every 2 seconds

Red blinks 4 times in 4 seconds

3.5.3 When the Bluetooth function is on, it goes into scanning mode, and the Bluetooth Con-

necting LED will blink Green and Red in turn every second. At this time, a Bluetooth

transmission device (such as a cell phone or computer) can be used to pair with the

BTM-311RH.

3.5.4 To turn off the Bluetooth Receiver, press the Bluetooth "Pair" Button for about 3 sec-

onds. The Bluetooth Connecting LED will blink Red 4 times and then goes off. This indi-

cates the Bluetooth Receiver is now off.

3.5.5 If the pairing process does not work, press the Bluetooth "Pair" Button 5 times to reset

the Bluetooth Receiver. When the Bluetooth Connecting LED flashes Red quickly, it in-

dicates the memory has been cleared, and the Bluetooth Receiver will go into the scan-

ning mode (LED blinks Green and Red in turn every second), please repeat the pairing

process.

3.5.6 When connecting a computer or cell phone with the BTM-311RH, the device name will

appear as "CAROL BTM-311RH", and the password is "0000" when needed.

4. Troubleshooting:

4.1 Cannot power on: Check if the DC adaptor is well connected.

4.2 No sound: Check if the speaker, AUX, and microphone cables are well connected.

4.3 Volume too low or too loud: Adjust the Volume Controllers to a suitable level, or adjust

the volume on the external sound source device (such as MP3 Player, CD player) /

Bluetooth sound source (such as cell phone, computer).

4.4 Bluetooth connect failed: It is suggested to delete the existing pairing from cell

phone/computer first, and then start a fresh device scan. The existing pairing in BTM-

311RH also needs to be cleared.

BTM-311RH Bluetooth Amplifier