Carolina Swing Boom Cutter Podręcznik właściciela/operatora - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik właściciela/operatora dla Akcesoria do ciągników Carolina Swing Boom Cutter. Carolina Swing Boom Cutter 20 stron.
Drukuj stronę
the cutter. This should allow a
more efficient material flow
under the cutter deck.
8.
Use the v-notch in the top of the
cutter deck to capture small trees
(up to 3" (76mm) for cutting.
Using V-Cut in deck for small trees
Vertical Cutting
Your Swing Boom Cutter has the
capability to cut vertically to widen
pathways, roadways, or along the edge
of a crop field to allow access for
tractors and combines.
can disperse debris over a large area.
To avoid an accident that could result
in Death or Serious Injury, do not
operate the cutter when bystanders
are within 300' (91m).
Serious Injury, never swing the cutter
boom past the side tipping capacity of
your skid steer when the cutter is in
the raised and vertical position. Know
the capability of your machine and
notice the terrain you are working on.
Raise the skid steer loader arm and tilt
the cutter head to the vertical position.
Swing the boom to the right to access
the area to be cut. Raise and lower the
skid steer's lift to trim back over-
hanging branches.
Carolina Attachments LLC.
Vertical cutting
To avoid Minor or
Vertical cutting along access road
Maintaining your
Attachment
Blade Removal &
Replacement
can be very sharp and could cause
Minor or Serious Injury if mishandled.
Always wear protective gloves and
footwear.
Plan your removal of the cutter blades
around the vicinity of an overhead
hoist. Position the cutter attachment
with cutter deck in the vertical position
so you can access the blade and holder
bracket.
Sling the holder from the hoist and
remove the 6 x ¾" bolts from the
center of the blade holder. Lower the
holder to the floor or to a suitable
work surface.
Use a cutting torch to remove the head
of the blade mounting bolt, and drive
the bolt shaft out of the blade holder
end.
Page 11
Cutter blades
Blades & Holder
Swing Boom Cutter
March 2016