Carolina Swing Boom Cutter Podręcznik właściciela/operatora - Strona 17
Przeglądaj online lub pobierz pdf Podręcznik właściciela/operatora dla Akcesoria do ciągników Carolina Swing Boom Cutter. Carolina Swing Boom Cutter 20 stron.
Drukuj stronę
Troubleshooting
Problem
Cutter bogs down
Vibration felt when
running cutter
Blades get dull too quickly
Blades breaking
Hydraulic oil level goes
down during operation
Blades do not spin when
flow is activated
Carolina Attachments LLC.
Cause
Deck is not properly
leveled & material is
balling under deck
Dull blades
Ground speed too fast
Cutter speed too slow
Missing, loose, damaged or
unbalanced cutter blades
Blade mount damaged
Gearbox loose on deck
Cutting height too low for
cutting in sandy or rocky
soils
Blades have contacted
solid objects (rocks, steel
pipes, etc.)
Excessive shock loads
Leak at valve, cutter motor
or other plumbing
Leaks in skid steer
hydraulic system
Shear bolt between motor
and gearbox is sheared
Motor or gearbox failed
Check valve failure
Page 17
Resolution
Refer to leveling
instructions found in this
manual.
Remove and sharpen
blades.
Slow down ground speed.
Raise engine RPMs or
investigate other low oil
flow problem
Replace blades with new or
re-sharpened and equally
balanced blades.
Replace blade mount
Tighten & torque gearbox
mounting bolts. Replace
bolts if they are damaged.
Raise cutter height.
Clear cutting area of solid
objects before hitting
them, or raise the cutter
height to clear exposed
rock surfaces.
Avoid hitting solid objects
(rock, steel pipes, large
tree stumps, etc.).
Investigate & repair
Investigate & repair
Replace with proper shear
bolt specified for this unit.
Disconnect the drive chain
between motor & gearbox.
If blade holder can be
turned by hand, motor
failure is suspect. Call the
Factory for further
instructions.
Remove check valve from
tees, cap the tees and
attempt to run cutter. If
cutter spins, replace the
check valve.
Swing Boom Cutter
March 2016