Carolina Extreme Duty XBC-8 Podręcznik właściciela/operatora - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik właściciela/operatora dla Przecinarka do zarośli Carolina Extreme Duty XBC-8. Carolina Extreme Duty XBC-8 16 stron.
Drukuj stronę
Installation:
jack or forklift to support the blade
holder during installation
Align the hole in the holder to gearbox
shaft fully seat the holder on shaft. Tap
with a hammer to assure full
engagement. Make sure the holder is
properly aligned and seated on
gearbox shaft splines. Install the six
capscrews and torque to the value
shown in the Hardware Torque table on
page 12 of this manual.
Blade Removal &
Replacement
can be very sharp and could cause
Minor or Serious Injury if mishandled.
Always wear protective gloves and
footwear.
Blade Removal:
accident that could result in Death or
Serious Injury, never find yourself in a
position where any body part is
located under an unsupported cutter
deck when servicing this attachment.
Remove the blade holder and cut the
head of the bolt off the bottom of the
blade. Drive the bolt shank from the
blade and holder, being careful not to
allow blade to fall off and contact your
foot or other body part.
Blade Inspection:
(sharpen or replace) the blades as a
set. Never run the cutter with
unmatched blades. Never install one
used and one new blade as they will
cause the cutter to be unbalanced and
Carolina Attachments LLC.
Use a hoist, power
/
"
3
4
Cutter blades
To avoid an
Always service
result in a vibration during operation
and may cause harm to other cutter
components.
Sharpen the blades with the
appropriate equipment, but be careful
not to overheat the blade steel causing
the blade material to become brittle
and prone to early failure. Grind both
blades to the similar shape and size
being careful not to create a
mismatched set of blades
Blade Installation:
Insert the new blade bolt up through
the hole in the blade and blade holder
and insert the nut in the recess hole in
the holder. Tighten the bolt into the
nut. Weld the inside diameter of the
nut to the outside diameter of the bolt
shank as shown in the following image.
Blade Installation
Blade Hardware Weld
Hydraulic System
of oil from a pinhole leak could
penetrate your skin if contacted. To
avoid an accident that could result in
Death or Serious Injury, never use
your hand or other body parts in an
attempt to locate a hydraulic leak.
hydraulic system pressure from the
cutter circuit prior to removing the
Page 11
Images
A small stream
Always release the
Extreme Brush Cutters
September 2018