ATIM ACW-DI2/868 Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przyrządy pomiarowe ATIM ACW-DI2/868. ATIM ACW-DI2/868 4 stron. Cloud wireless digital input
Drukuj stronę2.
INSTALLATION
Fente d'ouverture
Type de câble à utiliser: maximum length 1 meter and recommended diameter 0,9mm, the thread on 9mm.
In the few seconds following the implementation of the power supply, a first radio transmission is made (visible by a
brief blue blinking of the LED) to allow you to verify functioning of the modem.
It is necessary to open the case to get to the mini-USB port to
be able to configure the modem and to get to the terminal
block.
To do that, you have to insert the screwdriver into the slot
and tilt it downwards to lift the internal locking tab (cf.
photo). Then pull at the back of the casing to separate both
parts.
For optimal results, it is recommended to install the case
without environmental obstruction and to place it as high as
possible. For information, the antenna is integrated into the
case.
The case can be fixed on a flat wall or a tube following the
type of installation.
The orange button allows you to send a message to validate
the installation.
GND
Input 1
GND
Input 2
GND
You can connect up to two digital inputs in counting mode or in alert
mode by level detection. The signal must be realized by one contact or a
push-pull output that doesn't exceed 5V in high level. The 'Break of cable
' input is for a fraud detection if the modem is taken away, this
information is periodically sent during the remote reading of the meter.
www.atim.com
FRQIG_ACW-DI/868
Page2/4