Bosch WTW87569GR Instrukcja instalacji i obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Suszarka Bosch WTW87569GR. Bosch WTW87569GR 44 stron.
Również dla Bosch WTW87569GR: Instrukcja instalacji i obsługi (40 strony)
Drukuj stronę
For safety reasons, use
genuine spare parts and
accessories only.
Caution!
Material damage/damage to
the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain
removers, prewash sprays, etc.)
may cause damage if they
come into contact with the
surfaces of the appliance.
Therefore please note:
Do not allow these agents to
■
come into contact with the
surfaces of the appliance.
Clean the appliance with
■
nothing but water and a soft,
damp cloth.
Remove any detergent,
■
spray or other residues
immediately.
Energy-saving tips
7
Energy-saving tips
Spin the laundry before drying. The
■
E n e r g y - s a v i n g t i p s
drier the laundry, the shorter the
programme will be, in turn reducing
energy consumption.
Load the appliance with the
■
maximum loads permitted for the
programmes.
If the maximum load is
Note:
exceeded, this extends the programme
duration and increases energy
consumption.
Operate the appliance in a ventilated
■
room and make sure that the air inlet
on the appliance is unobstructed so
that air exchange can take place
unhindered.
Regularly remove the fluff from the
■
appliance. If there is fluff in the
appliance, this extends the
programme duration and increases
energy consumption.
If you do not perform any actions on
■
the appliance for an extended period
before the programme starts or once
the programme has ended, the
appliance will automatically switch to
Energy saving mode. The display
and indicator lights will go out after a
few minutes and Έναρξη/Παύση
(Start/Pause) A will flash.To end
Energy saving mode, all you need to
do is perform an action on the
appliance, such as opening and
closing the door.
If you do not perform any actions on
■
the appliance for an extended period
when it is in Energy saving mode,
the appliance will automatically
switch itself off.
en
11