Bosch WTW87T8LSN Instrukcja instalacji i obsługi - Strona 32

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Suszarka Bosch WTW87T8LSN. Bosch WTW87T8LSN 40 stron.

Drukuj stronę

Bosch WTW87T8LSN Instrukcja instalacji i obsługi

Faults and what to do about them

F a u l t s a n d w h a t t o d o a b o u t t h e m

Faults

ð on the display panel

and drying has been

interrupted.

é on the display panel. Clean the fluff filter and press the Start button ~ Page 26.

selfCleaning on the ó

display panel.

Dryer will not start.

Creasing.

Water is leaking out.

Change in the pro-

gramme duration dis-

played during drying.

Laundry is not dried cor-

rectly or is still too damp.

* Depending on the model

Cause/remedy

Empty the condensation container and press the Start button ~ Page 27.

■

If the optional condensation drain* is installed, the drain hose may be

■

blocked or kinked. Check the hose for deposits and rinse the hose. Lay the

hose without any kinks.

Not a fault. The heat exchanger is cleaned automatically. Do not pull out the con-

densation container while this is displayed.

Mains plug plugged in or fuse checked?

■

Programme selected? Select a programme.

■

Dryer door open? Close the door.

■

Is the childproof lock activated? Deactivate childproof lock.

■

"Ready in" time selected? Programme starts after a delay ~ Page 23.

■

Creasing occurs when you have exceeded the maximum load or selected

■

the wrong programme for the type of fabric. All the required information can

be found in the programme table ~ Page 21.

Remove clothes immediately after drying; creasing will occur if they are left

■

in the drum.

Not a fault; the dryer may be sloping. Level the dryer.

Not a fault. The moisture sensors detect the remaining moisture in the load and

adjust the programme length (except timed programmes).

After the programme has ended, warm laundry feels damper than it actually

■

is. Spread the laundry out and allow the heat to disperse.

Finely adjust the dryness level – this extends the drying time but does not

■

increase the temperature. Your laundry will become drier ~ Page 23.

Select a programme with a longer drying time or increase the dryness level.

■

This does not increase the temperature.

Select a timed programme to add extra drying time for laundry that is still

■

damp ~ Page 21.

Select timed program for a small load and individual items of laundry.

■

If you have exceeded the maximum load for the programme, the laundry

■

may not be dried properly.

Clean the moisture sensor in the drum. The sensor may become covered by

■

a fine layer of limescale or residues of detergents and care products which

then impair its function. Your laundry is not being dried correctly

~ Page 30.

Drying has been interrupted as a result of a power cut, because the conden-

■

sation container is full or because the maximum drying time has been

exceeded.

Note: .