Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K Instrukcja obsługi/bezpieczeństwa - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi/bezpieczeństwa dla Wiertarka Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K. Bosch 11536VSR - 36V Cordless 1" SDS-plus Litheon Rotary Hammer K 45 stron. Cordless hammer drill
Drukuj stronę
BM 1619929800 12-07
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed Fig. 1).
To reduce the risk of injury
!
WARNING
immediately discontinue use
of the tool if the variable speed control ceases
to function. Subsequent loss of on/off control
of the trigger switch is likely.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 9). This lever was designed for
changing rotation of the chuck, and for locking
the trigger in an "OFF" position to help prevent
accidental starts and accidental battery
discharge.
The selector dial allows the tool to be set for
various drilling/hammer drilling applications.
Rotate the selector dial right or left
depending on the below applications (Fig. 1).
Do
!
CAUTION
selection dial until the tool
come to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
Do not use demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
SLIP CLUTCH
The tool has a internal pre-set slip clutch. The
output spindle will stop rotating if the
accessory binds and overloads the tool.
When the trigger is released it activates the
electrical brake to stop the chuck quickly. This
12/4/07
8:32 AM
Operating Instructions
DRILL/HAMMER DRILL SELECTION DIAL
not
operate
the
BRAKE
Page 11
For forward rotation, (with chuck pointed away
from you) move the lever to the far left. For
reverse rotation move the lever to the far right.
To activate trigger lock move lever to the
center off position.
Do not change direction of
!
CAUTION
rotation until the tool comes to
a complete stop. Shifting during rotation of the
chuck can cause damage to the tool.
FORWARD/REVERSING LEVER
& TRIGGER LOCK
Drill only action: For drilling in
woods, metals, plastics or other
non concrete materials.
Drill with hammer action: For
drilling in concrete, asphalt, tile or
other similar hard materials.
is especially useful in the repetitive driving and
removal of screws.
VIBRATION DAMPER HANDLE /
HAMMER MECHANISM
The integrated vibration damper in the main
handle and hammer mechanism reduces
vibrations (Fig. 1).
-11-
FIG. 9