ATISAYA AUTO KISAN Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt rolniczy ATISAYA AUTO KISAN. ATISAYA AUTO KISAN 12 stron.

AUTO KISAN INSALLATION INSTRUCTIONS

3. To run the motor for a particular time, send a message M&TIME to auto kisan sim.

Ex: M30 – Here motor will automatically ON, run for 30 minutes and switch OFF

automatically after 30 minutes.

Motor Protection:

 Insert the given three current transformer coils to three phase wires which are located at starter.

This will save from dry bore, phase failure protection.

 Auto Kisan has high voltage protection

AUTO KISAN TROUBLESHOOTING STEPS:

1. AutoKisan is not switching ON (No LED):

2. Number switched OFF tone when calling:

ATISAYA ENGINEERING SERVICES

H.No. 12-1-28/B/N, Vijaya Gardens, Nagole, Bandlaguda Main Road, Hyderabad,

500068, India

a) Remove fuses and disconnect AutoKisan

and check whether 3 phases are available

using Multi-meter or Tester near the

fuses.

b) If 3 phases are live then check AutoKisan

wiring (Blue and Black should be

connected to any 2 fuse inputs).

c) Now connect fuses and wait for few

seconds for the LED light.

d) If the LED does not turn ON, open the

AutoKisan cap and take a photo of its

internals then report to service center

with the photos.

a) Check for AutoKisan LED indicator.

b) If the LED is not turned ON, go to

troubleshooting step 1.

c) If the LED is ON, remove fuses then

remove and reinsert SIM card according

to the instruction manual.

d) Reconnect fuses and call to the AutoKisan

device after getting blue LED.

e) If the issue still exists, remove fuses and

remove the SIM card and insert it into

any other mobile phone, then call to that

SIM and check for dial tone.

f) If the number is not ringing, replace the

SIM.

g) If the number is ringing, open the

AutoKisan cap and take a photo of its

internals then report to service center

with the photos.