Ativa LD 800 Podręcznik użytkownika - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Niszczarka do papieru Ativa LD 800. Ativa LD 800 15 stron.

Drukuj stronę

MAINTENANCE

Warning: Failure to properly maintain your shredder will void the warranty.

Keep your shredder running with ultimate reliability with the following Ativa shredder supplies:

Shredder Lubricant Sheets

To quickly and conveniently maintain shredder blade lubrication, use a Shredder Lubricant Sheet once

a month.

Shredder Oil

Apply a bead of this lubricant across a sheet of paper once a month and shred it. It helps to keep the

shredder blades operating well over many years of use.

Oil the shredder blades every month with recommended lubricant sheets (Office Depot item number

340-960) or oil (Office Depot item number 285-661).

Do not spray or keep any aerosol products in or around shredder.

DO NOT USE CANNED AIR ON SHREDDER.

CLEANING:

• ALWAYS UNPLUG THE SHREDDER BEFORE CLEANING!

• Only clean the shredder by carefully wiping the unit with a dry soft cloth or towel.

• Do not clean or immerse shredder in water. Having the unit wet may result in damage or

malfunction to the electrical components. If the shredder happens to get wet, be sure to completely

dry the unit immediately with a cloth or towel.

• Never use anything flammable to clean the shredder. This may result in serious injury or damage to

the product.

TROUBLESHOOTING

If there is a problem with your shredder, check below for the symptoms and steps to resolve. If you

continue to have problems, contact customer support at our Service Center. DO NOT ATTEMPT TO

REPAIR BY OPENING THE SHREDDER HEAD. This will completely void the product warranty.

The shredder does not work at all.

a) Make sure the unit is plugged in and that the outlet it is plugged into is in good working order.

b) Overheating with extended use: In the event that the shredder has shred continuously beyond

the maximum running time and overheating, the unit will automatically shut off. If this happens, switch

the shredder Off for 30 minutes or longer before resuming normal operation.

c) Be sure to NOT tilt the cover completely open beyond the preset position, otherwise

the SAFE FEED™ power cut off feature will be activated and the shredder will be

inoperable. The "SHREDDER STATUS" indication line must align with the "READY" setting.

d) If using a plastic bag to line the wastebasket, please remove it since this may be the cause of the

shredder to not operate properly.

e) The activation sensor of the shredder is located near the center of the feed slot. Be sure to feed

directly into the center area to activate the machine (especially applies to smaller pieces of paper or

credit cards).

f) When the "Basket is Full", the LED status indicator will indicate it needs to be emptied. While on,

the shredder will be inoperable until the wastebasket is cleared.

The shredder runs in "Rev (Reverse)" mode but not in "Auto (On)" mode.

a) While in "Auto" mode, the motor will not start running until paper is inserted into the feed slot. Set

the unit to "Auto" and insert paper to be shredded. The sensor that activates the shredder in Auto

mode is located directly in the center of the slot. If the paper you are inserting is narrow, it may not be

activating the optical sensor. It is possible that the feed slot has become blocked with paper. Insert an

index card or any rigid sheet of cardstock (old greeting card, file folder, or a sheet torn from a cereal

box), directly in the center of the feed slot, while applying force to help push the jammed paper

through. This will usually clear any paper blockage.

CONTINUED NEXT PAGE