Bosch 23612 Instrukcja obsługi/bezpieczeństwa - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi/bezpieczeństwa dla Wiertarka Bosch 23612. Bosch 23612 41 stron. Operating instructions
Drukuj stronę
INTENDED USE
This tool is intended for the fastening and
loosening of bolts, nuts and various threaded
fasteners. This tool is not intended for use
as a drill.
COLLET LOCKING SLEEVE
Insert a tool holder or screwdriver bit into the
chuck. Pull the collet locking sleeve forward.
Insert the desired bit into the chuck and
release the collet locking sleeve. The collet
accepts only standard 1/4" hexagonal shank
accessories with power groove. Do not use
this tool as a drill. Tools equipped with shut-
off clutches are not designed for drilling
applications. The clutch can shut off
automatically
Attempting to restart drilling after shut-off has
been reached can cause the tool to twist out
of your hand until the clutch again reaches
shut-off. Do not attempt to insert quick-
change type drill bits into this chuck.
REMOVING A TOOL HOLDER, SOCKET
OR SCREWDRIVER BIT
Pull the collet locking sleeve forward. Take
the tool out of the chuck and release the
collet locking sleeve (Fig. 2).
FIG. 2
COLLET
LOCKING
SLEEVE
CHUCK
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum
nameplate RPM by the pressure you apply to
the trigger. Apply more pressure to increase
the speed and release pressure to decrease
speed.
Operating Instructions
and
without
warning.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 1). This lever was designed
for changing rotation of the chuck, and for
locking the trigger in an "OFF" position to help
prevent accidental starts and accidental
battery discharge. For forward rotation, (with
chuck pointed away from you) move the lever
to the far left. For reverse rotation move the
lever to the far right. To activate trigger lock
move lever to the center off position.
!
CAUTION
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
BELT CLIP (Optional Accessory)
!
WARNING
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the
tool to fall resulting in injury to the operator or
bystanders.
The optional belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use.
To open clip, squeeze both release buttons
and the clip will spring up automatically
(Fig. 3). To use clip, turn tool upside down and
attach to your belt.
To retract clip when not in use, push down on
clip until it locks in the closed position.
-8-
Do not change direction of
rotation until the tool
When the tool is attached to
the belt, position yourself to
CLIP
RELEASE
BUTTONS
FIG. 3